User manual VTECH CRYSTAL SOUNDS DECT DIGITAL MONITOR

[. . . ] TM DECT digital monitor Contents 02. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Preparing Your Baby Monitor - Default Settings - Power - Positioning and Operating Range 13. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Baby Monitor Features - Turning the Units On/Off - Adjusting Speaker Volume - Adjusting Microphone Sensitivity - Sound Level Indicators & Sound Alert - Paging the Parent Unit - Playing Lullabies - Out of Range Alert 17. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Appendix - Cleaning and Maintenance - Storage - Replacement - Environmental Notices - FCC and IC Regulations - RF Radiation Exposure Statement 25. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Indoors, the operating range is up to 150 feet. Preparing Your Baby Monitor 11 · After a long period of non-use, recharge the parent unit before using. Technical Specifications: Dry Materials Wood, plaster, cardboard, glass (without metal, wires or lead) Brick, plywood Material Thickness < 12 inches < 12 inches < 12 inches < 1/2 inch < 1/2 inch Loss of Range 0-10% 5-35% 30-100% 90-100% 100% Preparing Your Baby Monitor 12 Reinforced concrete Metal grills or bars Metal or aluminium sheets Note: For wet and moist materials, the loss of range may be up to 100%. Baby Monitor Features Turning the Units On/Off Baby unit 1. Press and hold the on/off button for about 2 seconds to turn on the unit. Press and hold the on/off button for about 2 seconds to turn off the unit. Press and hold the on/off button for about 2 seconds to turn on the unit. The secure link indicator will blink red as the parent unit searches for a secure connection to the baby unit. If a secure connection is not made within about 30 seconds to one minute, the secure link indicator will shine steadily red. When a secure connection is found, the light will shine steadily green. LINK ! ! ON LINK LINK LINK LINK 6. To stop the paging alert tone, press the PAGE button again, or press any button on the parent unit. Playing Lullabies 1. When there is no lullaby playing, press the lullaby button or the play/stop button on the baby/parent unit to start playing lullabies. Press +/- buttons on baby unit to adjust lullaby volume. Note: · The lullabies will play continuously for approximately 15 minutes. To preserve battery life, the unit will automatically stop playing lullabies after approximately 15 minutes without input. To reactivate the lullabies, press the lullaby button or play/stop button. · The lullaby volume on the baby unit cannot be changed using the parent unit. Baby Monitor Features 15 Paging the Parent Unit Lullabies 1. Happy Farmer - Schumann Baby Monitor Features Out of Range Alert 1. When the parent unit is out of range of the baby unit, the secure link indicator on the parent unit will flash. After about 20 seconds, the parent unit will beep and the secure link indicator will shine steadily red. Once the connection between the parent and baby units has been established, the secure link indicator will shine steadily green. LINK LINK LINK 16 Troubleshooting Problem Secure link indicator on parent unit does not light up when the on/off button is pressed. Replace with new alkaline batteries or connect the baby unit to the power supply. Secure link indicator on parent unit flashes. Baby unit and parent unit may be out of range of each other. Baby unit may be turned off. Reduce the distance between the units, but not closer than 3 feet. Replace alkaline batteries or connect the baby unit to the power supply. Recharge the parent unit with the adaptor. Battery light on baby unit flashes. Battery light on parent unit flashes. Alkaline batteries in baby unit are running low. Rechargeable batteries in parent unit are running low. Troubleshooting 17 Baby unit and parent unit may be out of range of each other. Move the parent unit closer to the baby unit, but not closer than 3 feet. Problem Parent unit beeps. Possible causes Parent unit has lost connection with baby unit. Solutions Reduce the distance between the units, but not closer than 3 feet. [. . . ] Deposit them at an official collection center for battery recycling. FCC and IC Regulations FCC Part 15 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and applicable Industry Canada specifications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]