User manual VOSS MYR1150-AL

[. . . ] 11 Stainless steel surfaces . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 The wok . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Something not working . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Service and spareparts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If you are unsure about the meaning of these warnings contact the Customer Care Department for assistance. Child Safety Young children must not be allowed to tamper with the wok or play with the control. Children should be kept away until the wok has cooled. Installing This wok must be installed according to the instructions supplied. Any installation work must be undertaken by a qualified competent person. Do not alter the specifications or attempt to modify the appliance in any way. Maintenance and Cleaning Only clean this wok in accordance with the instructions given in this book. Service Repairs carried out by inexperienced persons may cause injury or serious malfunction of the appliance. Contact your local AEG Service Centre. During Use The wok is intended for domestic cooking only. Do not use the wok if it is damaged in any way, contact your local AEG Service Centre. Never leave the wok unattended while deep fat frying, or heating fats and oils. Disposal Make the wok unusable by cutting off the cable. Dispose of any packaging material and old appliances at an authorised disposal site. 4 Description of the product Burner Knob Placement of grid Guide pins for grid 5 Operating instructions Burner markings Off. flame The operating knob has a ring showing the scale of markings. 6 Burner cover/burner ring Together with the burner ring the burner cover forms a space where the final mixture of gas and air takes place in order to make the gas burn correctly. Please note: It is consequently very important that the burner cover/ring is placed correctly on the burner. The burner ring has been provided with holes for the ignition electrode, and the thermo sensor. The hob should not be installed in a bed sitting room with a volume of less than 20 m³. If it is installed in a room of volume less than 5 m³ an air vent of effective area of 110 cm² is required. If it is installed in a room of volume between 5 m³ and 10 m³ an air vent of effective area of 50 cm² is required, while if the volume exceeds 11 m³ no air vent is required. However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m³ and 11 m³. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements. This hob must be installed by qualified personnel to the relevant British Standards. Any gas installation must be carried out by a CORGI registered installer. The maufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored 13 Gas connection Gas installation In accordance with local requirements for domestic gas cooking appliances. For gas types see technical data. Gas connection The gas intake is situated at the lower rear of the appliance. The intake has a ½" conical pipe thread (see fig 1) If the appliance is to be connected to a gas cylinder, conversion with the optional modification kit will be necessary. Fig 1 Pressure test The unit should be pressure-tested at Max. 150 mbar. 14 Mounting MIN 55 Caution: In order to avoid a hazard this appliance must be installed according to these instructions for installation The hob unit can be mounted in any type of kitchen with a table surface whose thickness is between 28 mm and 40 mm. Headroom The distance to any shelves or tops of a cabinet under the hob is to be at least 55 mm. Fixing Screw the fixing brackets out to such an extent that they can be turned in under the table top. [. . . ] Sympton: There is no spark when lighting the gas Solution Check hob is connected to the electricity supply. Check the fuse and replace if necessery. When the operating knob is released the gas ring goes out again The operating knob has not been depressed long enough, or has not been depressed sufficiently. after cleaning. The gas ring burns unevenly If after all these checks, your hob still does not operate correctly, contact your local AEG Service Force Centre. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. [. . . ]