User manual VOODOO LAB MX-28M INFORMATION

[. . . ] Warranty Card Please take a moment to fill in and mail the warranty card now. INSTALLATION Connect your MIDI cables as follows: MX-28M Inputs Route the OUTPUT from one "source" (e. g. MX-28M Outputs Route each of the eight MX-28M OUTPUTS to the INPUTS of your tone modules, sequencer, etc. [. . . ] Each zone is then output on its own MIDI channel to each selected output. The first defined zone is transmitted on the same MIDI channel number as the input channel number, and each of up to three additional zones are output on the next higher MIDI channel number. Example: If four zones are defined and the input channel is MIDI channel 4, the zones will be output as follows. zone 1 on channel 4 zone 2 on channel 5 zone 3 on channel 6 zone 4 on channel 7 Select MAP (the uppermost position) with the Function Select Switch. The default MAP sends the entire keyboard range to all four zones (i. e. When the PGM button is pressed, the Red LED above the word "RANGE" will blink to indicate that Range #1 can now be entered, and the Green LED above the word "LOW" will illuminate. Enter the low note for the first RANGE from your controller connected to INPUT1. Continue entering ranges, --low note first, then high note--until you have defined four ranges. If you want fewer than four ranges, press the PGM button after playing the high note of the last RANGE you wish to define. If a RANGE is defined by entering the higher note first, then no notes will be output from that zone. Example 1 INSTANT LAYERING: If you wish to send all notes on four channels to each selected OUTPUT, select MAP with the Function Select Switch. Data on four consecutive channels (starting with the input channel number) will be sent to each selected OUTPUT. If your controller is sending on MIDI channel 1, data will be sent on 1, 2, 3 and 4 simultaneously. Example 2 SPLITS: To split your controller so that the lower half is output on channel 1 and the upper half is output on channel 2, perform the following steps: 1. MIDI data for each zone is sent to each selected output (zone 1 on MIDI channel 1; zone 2 on MIDI channel 2). Overlapping zones are programmed the same way, just play the intervals that define your zones, low note first, then high note. [. . . ] If the product should become defective within the warranty period, Digital Music will repair it or replace it free of charge, provided it is returned freight prepaid to Digital Music with a valid RMA (return material authorization) number. This warranty shall not apply to any goods that have been repaired or altered by anyone other than the manufacturer. There are no warranties which extend beyond the terms described herein. [. . . ]