User manual VOLTCRAFT VC265 V06-10

[. . . ] The symbol can be found when you are to be given tips and information on operation. We do not assume liability for resulting damages to property or personal injury if the product has been abused in any way or damaged by improper use or failure to observe these operating instructions. Carefully read the whole operating instructions before operating the device, otherwise there is risk of danger. Dear Customer, the following safety instructions are intended not only for the protection of your health but also for the protection of the device. [. . . ] ⷠIn schools, training centres, Hobby and DIY workshops, the handling of measuring appliances must be responsibly supervised by trained personnel. ⷠWhen used in conjunction with other devices, observe the operating instructions and safety notices of connected devices. ⷠThe product must not be subjected to heavy mechanical stress or intense vibration. The product should not be used immediately after it has been brought from an area of cold temperature to an area of warm temperature. Wait until the product adapts to the new ambient temperature before use. ⷠIf there is reason to believe that safe operation is no longer possible, put the device out of operation and secure it against unintended operation. Safe operation is no longer possible if: - the product shows visible damages, - the product no longer works and - the product was stored under unfavourable conditions for a long period of time, - the product was subject to considerable transport stress. ⷠThe manufacturer or supplier accepts no responsibility whatsoever for incorrect displays or the consequences which can arise from such incorrect displays. ⷠWhen installing the battery, make sure to pay attention to the correct polarity. ⷠDo not let batteries/rechargeable batteries lie around openly. Leaking or damaged batteries/rechargeable batteries may cause acid burns when coming into contact with skin, therefore use suitable protective gloves. duringthemeasurement , thegreenLEDflashesatthefrequencysetinthe"LEDFlashCycle Setup". To stop the measurement manually, hold down the Data Logger button for two seconds. Once the memory of the data logger is full, the measurement is terminated automatically. The recording can also be terminated at any time by displaying the readout on the computer before the recording is complete (see chapter "Displaying data logger readout"). LED signals and their meaning Signal Description flashes once at the frequency set active measurement, readings do not exceed / under "LED Flash Cycle Setup". Under-run the alarm limit values Green (REC) flashes twice at the frequency set with time-delayed start of measurement under "LED Flash Cycle Setup". Flashestwiceevery30seconds reading under-runs alarm lower-limit value flashes three times every 30 reading exceeds alarm upper-limit value Red (ALm) seconds flashesonceevery20seconds weak battery flashesonceevery2seconds temperature sensor not properly connected Red + Green flashesonceevery60seconds memory full --no LED on logger turned off or batteries empty LED You can also click on the icon with the white arrow with blue background. To save the data, choose "File ­ Save" from the menu. Keeping the data logger connected to the USB port of the computer for extended periods can result in a premature discharge of the battery. Turn the data logger around and insert the battery into the battery compartment observing the right polarity. Make sure not to damage any cables or pipes behind the wall when drilling dowel holes. [. . . ] Insert the dowels and secure the wall bracket in vertical alignment on the surface using the screws. Alternatively, attach the wall bracket using the double-sided adhesive tape applied to theback. todothis , removetheprotectivefilmandpressthewallbracketagainstthe desired surface. The adhesive tape reaches its full adhesive strength for bonding only at temperatures over 5 °C. [. . . ]