User manual VOLTCRAFT PL-130 AN

[. . . ] ⷠIf you have queries about handling the device, that are not answered in this operating instruction, our technical support is available under the following address and telephone number: Voltcraft®, 92242 Hirschau, Lindenweg 15, Germany, phone 0180 / 586 582 7 The following units can be selected: - Feet per Minute (ft/min) - Kilometres per hour (Km/h) - Miles per hour (MPH) - Knots (knots) The last unit used is memorized when the anemometer is turned off. No maintenance is necessary for the device apart for occasional cleaning and the changing of the battery. ⷠClean the exterior of the device with a soft, dry cloth or brush only. [. . . ] ⷠThe product must not be subjected to heavy mechanical stress. Jolts, impacts or a fall even from a low height can damage the product. ⷠIn schools, training facilities, hobby or self-service workshops, handling of electrical devices must be monitored by trained personnel. ⷠWhen operating on commercial premises, the relevant accident prevention regulations of workers' compensation boards for electrical equipment must be observed. ⷠMake sure there are no devices with strong electric or magnetic fields such as transformers, motors, cordless telephones and radio-controlled devices in the vicinity of the product as these can influence the product. ⷠDo not switch the product on immediately after it has been taken from a cold to a warm environment. Unscrew the screw on the battery compartment cover using a Phillips screwdriver and take off the cover of the battery compartment. Press the button "UNITS" until the display unit is switched to cubic feet per minute (CFM) or cubic meter per minute (CMM). You need to input the correct cross section area of the gas flow before the The user is legally obliged (battery regulation) to return used batteries and anemometer can give you the correct air flow measurement. Disposing used batteries in the household waste button "AREA", after two "beep" sounds, you can input the gas flow area. The symbol - Use the button "HOLD" to move to the next digit. Press and hold the button "AREA" to return to the measuring mode, you will hear Cd = Cadmium, Hg = Mercury, Pb = Lead. The display now shows the air You can return used batteries/ rechargeable batteries free of charge to flow measurement. Any collecting point of your local authority, our stores or where batteries/ rechargeable batteries are sold. ⷠIfoneofthemultipliers(x10orx100)appearsbelowthereading, multiplythe Consequently you comply with your legal obligations and contribute to environmental reading by the multiplier to obtain the correct value. During the measurement process press the button "MAX / MIN" once to display Scan rate: after approx. Press it three Auto switch-off time: Operating temperature: 0 ºC to +50 ºC, < 80 % RH times to display the average value. Press the button "MAX / MIN" four times to Storage temperature: -10 ºC to +60 ºC, < 80 % RH return to normal measuring mode. [. . . ] The auto power off function resumes whenever the anemometer is restarted. ⷠBatteries should be removed from the device if it is not used for a long period of time 2. Leaking or damaged batteries might cause acid burns when in contact with skin, therefore use suitable protective gloves to handle corrupted batteries. [. . . ]