User manual VIVANCO UR82

[. . . ] - If you notice the reaction of your appliance too late and the next code has already been emitted you can go back by pressing SET and then ON/OFF again. If your appliance has switched itself off you must switch it back on again, e. [. . . ] - Remember to switch your appliance back on again if you wish to continue searching. Code identification You can read off the 3-digit codes you have set at any time: 1. Press the appliance button of the appliance whose code you want to read off, e. Press the SET button and additionally 1, 2 or 3, depending on the part of the code you want to read off. For example, if you press SET+1 and the code 153 (in this example) has been set, the lamp blinks once after SET+1 is released to show that the hundred figure is 1. (GB) Instructions Inserting the batteries Open the battery flap on the back of the remote control, press the tongue lightly downwards, then insert 2 alkaline AAA batteries. Check that the polarity markings on the batteries and in the battery compartment are correctly lined up (+=+), then close the flap carefully. There are two ways of doing so: direct control code entry or code search. If your UR82 does not understand you it blinks and you can then repeat the entry. Direct control code entry using the enclosed list Example: setting to control a Panasonic television set: 1. [. . . ] Exceptions: missing codes, deliberate destruction and normal wear and tear of the housing and buttons. TV eller en DVB Set Top Box (eller satellitmottagare/ kabeltuner) eller en annan apparat För att du ska kunna styra dina apparater måste du ställa in fjärrkontrollen till dina apparater, så att den passar till resp. [. . . ]