User manual VIVANCO UR 89

[. . . ] Please make sure you have selected the correct list for television sets (TV). To prepare code entry, press the SET button, keep it pressend and then press the required appliance button, e. Once the numbers have been entered the button lamp goes out and the remote control is ready to control your appliance. Finally, test the control code setting by trying to control (in this example) your television set. [. . . ] Code search If the brand of your appliance is not in the list or none of the codes given fits, we recommend a code search. To prepare code search, press the SET button, keep it pressed and then press the required appliance button, e. ­ Except when searching for a TV code you can also briefly press the yellow > (Play) button and use the Play function to search. Make sure that a tape, a DVD or a CD is inserted in the tape deck, player or recorder. - If you notice the reaction of your appliance too late and the next code has already been emitted you can go back by pressing SET and then ON/OFF or Play again. If your appliance has switched itself off you must switch it back on again, e. - When your appliance reacts you can also try out other buttons without interrupting the search. If some buttons do not work properly, simply continue searching with ON/OFF or Play. - The UR 810 continues with the search at the point where you interrupted it. When the end of the code list is reached the search stops automatically. DVD) on your UR 810 remote control blinks twice, then lights up for 2 seconds and then starts blinking again. - If there is a learning(capturing) problem, the LED blinks 4 times, lights up for 2 seconds and then will start blinking again. ­ The controller will exit the learning mode automatically after about 30 seconds of inactivity. Reset/deletion of all captured key functions per device: press the right device selection key, e. DVD, and then SET and 4 together in order to delete all learnt functions. Memory full indication: if the memory is full, a LED blink 4 times and then the controller will exit learnning mode. Operation You operate your appliances basically in exactly the same way as if you were using the original remote controls, except that you must first press an appliance button (TV, DVD, etc. As the symbols on the UR 810 could differ from those on the original remote controls you may have to try out all the buttons in order to find the functions. Assigning volume and mute exclusively to one appliance (punch through function: Press the appliance button of the appliance that you always want to use for volume control, e. Device Selection Key Shift: In order to change the function of a device selection key, e. [. . . ] Device Selection Key Shift: In order to change the function of a device selection key, e. Change device key AUX1 to a second SAT device key proceed as follows: a) Press SET hold it and then press the to be changed device key, e. B) Press SAT, the light goes off and you can enter another SAT code for a second SAT or DTT receiver under AUX1. C) You can reset this function by pressing SET and the modified device key (AUX1) simultanously until the LED goes on. [. . . ]