User manual VIVANCO UR 1300

[. . . ] Dispose of used batteries according to the manufacturer's instructions. Adapting to appliances In order to control your appliances you must adapt or set the remote control to them:. Direct control code entry using the enclosed list Example: setting to control a Panasonic television set: 1. [. . . ] Direct control code entry using the enclosed list Example: setting to control a Panasonic television set: 1. Please make sure you have selected the correct list for television sets (TV). To prepare code entry, press the SET button, keep it pressed and then press the required appliance button, e. Once the numbers have been entered the lamp goes out and the remote control is ready to control your appliance. Finally, test the control code setting by trying to control (in this example) your television set. If it does not work at all or not correctly try a different code from the list or the code search (see below). to set the remote control for other appliances , proceed in the same way. The letters on the device buttons TV, DVB, DVD, AUX are for your orientation only. ­ If you ended the search too late, continue to search using the Manual Code Search (see above). Finally, test the control code setting by trying to control, for example, your DVD appliance. Code identification You can read off the 3-digit codes you have set at any time: 1. Press the appliance button of the appliance which code you want to read off, e. Press the SET button and 1, 2, 3, depending on the part of the code you want to read off. For example, if you press SET+1 after TV and the code 176 (in this example) has been set, the lamp blinks once after SET+1 is released to show that the hundred figure is 1. Operation You operate your appliances basically in exactly the same way as if you were using the original remote controls, except that you must first press an appliance button (TV, DVB, etc. As the symbols on the UR 4 SL could differ from those on the original remote controls you may have to try out all the buttons in order to find the functions. [. . . ] For example, if you press SET+1 after TV and the code 176 (in this example) has been set, the lamp blinks once after SET+1 is released to show that the hundred figure is 1. Operation You operate your appliances basically in exactly the same way as if you were using the original remote controls, except that you must first press an appliance button (TV, DVB, etc. As the symbols on the UR 4 SL could differ from those on the original remote controls you may have to try out all the buttons in order to find the functions. [. . . ]