User manual VIVANCO UR 810 UNIVERSAL CONTROLLER

[. . . ] There are three ways of doing so: direct control code entry, code search or learn. If your UR 810 does not understand you, it blinks several times and you can then repeat the entry. Each understood entry is confirmed by an appliance button blinking once briefly. [. . . ] To start the code search, press the SET button, and then additionally the required appliance button, e. Then point the remote control at the appliance to be controlled while the remote control emits a different ON/OFF signal every 2 seconds. When your appliance reacts, press any button, except SET, to end the search. ­ If you ended the search too late, continue to search using the Manual Code Search (see above). Finally, test the control code setting by trying to control, for example, your DVD appliance. Code identification You can read off the 3-digit codes you have set at any time: 1. Press the appliance button of the appliance which code you want to read off, e. Press the SET button and 1, 2, 3, depending on the part of the code you want to read off. For example, if you press SET+1 after TV and the code 156 (in this example) has been set, the lamp blinks once after SET+1 is released to show that the hundred figure is 1. The standard code may provide most of functions needed, but you may miss some key functions. Or you didn´t find any functioning preprogrammed code for a device. 1 For learning of key codes you must use a functioning orginal remote controller. 2 Please point the original´s remote control transmitter LED towards the receiver LED of UR 810 (placed on top , same as transmitter LED). Distance of LEDs between both remotes shall be approximately 30mm and must be in straight line of sight. [. . . ] Reset remote control to factory settings: Press SET and 0 simultanously for more then 3 seconds. a LED will flash twice and all user settings will be deleted Specifications Batteries: 2x AAA batteries , R03 , UM4 Range: max. 7 m Not for 400 kHz equipment 2-year works guarantee Should your UR 810 cease to work within 2 years of purchasing you will receive a free replacement from VIVANCO. [. . . ]