User manual VIVANCO UR 5000

[. . . ] Once the numbers have been entered the lamp goes out and the remote control is ready to control your appliance. Finally, test the control code setting by trying to control (in this example) your television set. [. . . ] Or you didn´t find any functioning preprogrammed code for a device, e. 1 For learning of key codes you must use a functioning orginal remote controller. 2 Please point the original´s remote control transmitter LED towards the receiver LED of UR 5000 (placed on top , same as transmitter LED). Distance of LEDs between both remotes shall be approximately 5080mm and must be in straight line of sight. 3 To prepare copying of key functions, press the required appliance button, e. 4 Press and hold down P+ and VOL- simultanously for 3 seconds until the indicator led (2) lights up. 6 Press and release the target key, that you want to learn to (reprogram) (e. You can access "free" keys, if you press Shift key (9) first. Upto 3 pages, accessable by Page key (10), are available for any device for copying original keys. POWER) until the LED on your UR 5000 remote control blinks once and the device icon, e. Then adjust the position of both Remote controls and start capturing the key function again at step 6. ­ The controller will exit the learning mode automatically after about 15 seconds of inactivity. In case a copied key operates occasionally only, please try the following modified method: 1. Press and release the target key, that you want to learn to (reprogram) (e. [. . . ] Hold down "P+" & "VOL-" together simultaneously for 3 seconds until the led indicator (2) lights up. - Smart keys1, 2, 3 are directly accessible, for 3 further Smart Action keys Shift and then Smart 1, 2 or 3 must be pressed. [. . . ]