User manual VIVANCO FMH 6050 RF HEADPHONE SET

[. . . ] 3 Frequency selector switch Using this switch you can alter the transmission frequency in order to prevent over lapping with other transmitters (channel 1, 2 or 3). 4 Audio input socket The transmitter can be connected to the sound source (e. 5 Low voltage socket Connect the AC adapter (C) here for the transmitter's power supply. 6 Battery pack charge socket Using this socket and the charge lead you can recharge the battery packs of the headphones without having to remove them from the battery pack compartment. [. . . ] Connection to the audio source If your audio source is fitted with a jack socket (e. Connect one end of the lead to the headphones socket and the other to the audio input socket (A4) on the transmitter. If the jack plug is too small for the headphones socket, you can use the adapter (G) from 3. If your hi-fi or TV is not fitted with a headphones socket you can also use the phono output (AUX) by means of the Y adapter. Make sure that plug and socket colours are matched correctly (right = red, left = white). When using adjustable headphone sockets, make sure that these are turned up high enough (roughly in the middle position). The FMH 6050 comes with 2 rechargeable batteries (of the Micro AAA type), to be charged before you use your new appliance for the first time. Prior to first operation, the batteries have to be charged during approximately 14 hours. After this initial charge, the batteries will remain fully charged for about 8 hours. Please note that the batteries will reach their full capacity, and thereby the operation time stated, only after the third charging operation. Useful hints on battery maintenance Perfect maintenance of your rechargeable batteries requires that you discharge / recharge them about once per month with an appropriate charger. for this purpose , we recommend chargers of the Vivanco product line. Regularly used, these appliances provide for longer useful life of your rechargeable batteries. The transmitter automatically switches itself off when there is no audio signal for a prolonged period or the input signal is too weak. The transmitter automatically switches itself back on when there is an audio signal. If this lamp does not come on, you must first recharge the battery packs for the headphones (see section 5. First, turn the tuning knob (B9) in one direction until you feel it catch. Then turn the tuning knob (B9) slowly in the other direction until you can hear a clear sound signal (speech or music). Your headphones are now set to the transmission frequency (A3) that you previously set on the transmitter (section 4. When the fine tuning of the transmitter is optimal, the power-on lamp (B10) lights green. If you receive interference or other transmitters, turn the tuning knob (B9) again. Using batteries (rechargeable or one-way) The wireless headset can also be supplied with commercially available rechargeable or non-rechargeable 1. [. . . ] Transmitter switches itself off Increase the volume at the headphones socket or the phono output of your audio source. If the audio signals are too weak the transmitter will otherwise switch off automatically. If these suggested solutions do not lead to the desired result, please contact your dealer. The FMH 6050 is subject to a strict quality inspection in order to guarantee maximum functionality. [. . . ]