User manual VITEK VTM-14A

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference with radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference with radio or television reception, which can be determined by turning the equipment off and on, the user should correct the interference by taking one or more of the following actions: - Re-orient or relocate the receiving antenna. - Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. [. . . ] Exception: A product that is meant for uninterrupted service and that for some specific reason, such as the possibility of the loss of an authorization code for a CATV converter, is not intended to be unplugged by the user for cleaning or any other purpose, may exclude the reference to unplugging the product in the cleaning description otherwise required in 5). 6) Attachments Do not use attachments not recommended by the product manufacturer as they may cause hazards. 7) Water and Moisture Do not use this product near water, for example near a bath tub, wash bowl, kitchen sink, or laundry tube in a wet basement or near a swimming pool and the like. 8) Accessories Do not place this product on an unstable cart, stand, tripod, bracket or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. Use only with a cart, stand, tripod, bracket or table recommended by the manufacturer, or sold with the product. Any mounting of the product should follow the manufacturer's instructions, and should use a mounting accessory recommended by the manufacturer. Quick stops, excessive force, and uneven surfaces may cause the product and cart combination to overturn. 10) Ventilation Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating and these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. 23) Safety Check Upon completion of any service or repairs to this receiver, ask the service technician to perform safety checks to determine that the product is in proper operating condition. 24) Wall or Ceiling Mounting The product should be mounted to a wall or ceiling only as recommended by the manufacturer. 25) Heat The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. 2 3 FRONT PANEL CONTROLS REAR PANEL CONNECTIONS 1 2 3 4 5 6 7 8 VIDEO INPUT The Video button changes to A and B and it changes input mode. Select the Sharp button to control the frame of the screen with the Volume (Data) button. (50 is the normal size) BRIGHT The Bright button controls the brightness of the screen. Select the Bright button to control the brightness of the screen with the Volume (Data) button. (50 is the normal brightness) TINT The Tint button controls colors close to the natural one. To get the most optimal color, target one of the skin colors and change it close to the primary color. Select the Tint button to control colors with the Volume (Data) button. (50 is the normal color) COLOR The Color button controls the density of the colors. Select the Color button to control the density of colors with the Volume (Data) button. [. . . ] Controlling volume: This button controls the volume of the sound without pressing other buttons POWER This button is to turn on and off the Monitor. The Power button connects to the electricity and the LED is turned on. After installing a camera, use a cable to connect the video/audio output connectors of the camera to the each "A" video/audio input connector on the back of the monitor. Use a cable to connect the video/audio input connectors of the VCR to the each "A" video/audio output connector of the monitor. [. . . ]