User manual VITEK VTM-142C

[. . . ] Products returned after (30) days are subject to refusal of returned merchandise. 14" Color Monitor With 420 TVL & Audio VITEK · 420 TV Lines At Center on a 14" Diagonal Screen · Attractive Black Metal Cabinet · Digital Front Panel Controls For: Sharp / Bright / Tint / Color / Contrast & Volume / A/B Switching 9970 GLENOAKS BLVD. UNIT B SUN VALLEY, CA 91352 PHONE: 888-VITEK-70 / 818-771-0300 FAX: 818-771-0400 WWW. VITEKCCTV. COM | SALES@VITEKCCTV. COM · Front Panel A/B Switch · 2 Looping Video Inputs & Dual Audio In / Out · Rack Kit Available: VI-141CRM 8 CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER, NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. NOTE : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. [. . . ] 10) Ventilation Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating and these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. 11) Power Sources This product should be operated only from the type of power resource indicated on the marking label. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company. For products intended to operate from battery power or other sources, refer to the operating instructions. 12) Grounding or Polarization This product is equipped with a three-wire groundingtype plug a plug having a third (grounding) pin. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. 13) Power-Cord Protection Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product. 14) Protective Attachment Plug The product is equipped with an attachment plug having overload protection. See instruction Manual for replacement or resetting of protective device. If replacement of the plug is required, be sure the service technician has used a replacement plug specified by the manufacturer that has the same overload protection as the original plug. 15) Outdoor Antenna Grounding If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrodes. 16) Lightning For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug the product from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power line surges. 17) Power Lines An outside antenna should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. [. . . ] Select the Tint button to control colors with the Volume (Data) button. (50 is the normal color) COLOR The Color button controls the density of the colors. Select the Color button to control the density of colors with the Volume (Data) button. [. . . ]