User manual VICTRON ENERGY 24-1600 230V

[. . . ] Consult the battery manufacturer's information to ascertain that the product is intended for use in conjunction with the battery. Always comply with the battery manufacturer's safety instructions. Read the installation instructions in the installation manual before installing the equipment. This is a Safety Class I product (supplied with a protective grounding terminal). [. . . ] Remote control is possible with a simple on/off switch or with a Phoenix Inverter Control panel. Alarm: overload, or battery voltage low, or inverter temperature hig, or DC ripple voltage on battery terminal was too high. The product must be installed in a dry and well-ventilated area, as close as possible to the batteries. There should be a clear space of at least 10cm around the appliance for cooling. The appliance can be mounted horizontally as well as vertically; vertical mounting is preferable. The interior of the product must remain accessible after installation. Try and keep the distance between the product and the battery to a minimum in order to minimize cable voltage losses. For safety purposes, this product should be installed in a heat-resistant environment if it is used with equipment where a substantial amount of power is to be converted. In order to fully utilize the full capacity of the product, batteries with sufficient capacity and battery cables with sufficient cross section should be used. Remark: Internal resistance is the important factor when working with low capacity batteries. Please consult your supplier or the relevant sections of our book "electricity on board", downloadable from our website. Procedure Proceed as follows to connect the battery cables: Use an insulated box spanner in order to avoid shorting the battery. (Safety fuse inside the MultiPlus Compact can be damaged) Secure the nuts tightly in order to reduce the contact resistance as much as possible. This is a Safety Class I product (supplied with a protective grounding terminal). the neutral wire of the AC output of this inverter is connected to the chassis. This is to ensure proper functioning of a GFCI (or RCCB) to be installed in the AC output of the Inverter. The chassis of the product must be connected toground, to the frame (of a vehicle) or the ground plate or hull (of a boat). Procedure The AC output cable can be connected directly to the male-connector at the bottom of the enclosure. From left to right: "N" (neutral), earth, and "L1" (phase). 1 Remote on/off switch & remote Control panel The product can be remotely controlled in two ways. Programmable relay The inverters are equipped with a multi-functional relay that by default is programmed as an alarm relay. 3 Parallel Connection The inverters can be connected in parallel with several identical devices. [. . . ] The system can be configured without a dongle, and will be fully functional during 15 minutes (as a demonstration facility). Net you can set all parameters, with the exception of the multi-functional relay and the VirtualSwitch. Some settings can be changed with DIP switches Procedure: a) Turn the Compact on, preferably without load. C) Store the settings by moving Dip switch 8 to "on" and back to "off". [. . . ]