User manual VICTORINOX SWISS ARMY HUNTER MACH 2

[. . . ] Setting the Date and the Time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Turn the crown away from you until the date showing is the day before the desired setting. Pull out the crown to the fully extended position (3) and rotate toward you. Push in the crown and screw down, away from you, until it is sealed tight into its normal position (1). TO SET TIME ALONE: Unscrew the crown by turning it toward you to get to unscrewed position (2) and refer to instructions "C". 5 The crown has 3 positions: 1. Fully extended position: to set the time NOTE: You must always push in and screw down the crown to form a water-resistant seal with the case. Never operate the crown when the watch is wet. 4 DISPLAY-WATCH HANDS 60 second timer (Split-seconds hand) 30 minute timer Pushbutton C 60 second timer 1/10 second timer Pushbutton A SETTING THE TIMERS TO ZERO Set the hand of the 30 minute timer to zero Set the hand of the 60 second timer to zero SPLIT-second hand Setting crown Set the hand of the 60 second timer to zero Set the hand of the 1/10 second timer to zero Pushbutton B Date indicator Minute hand 6 Hour hand Seconds hand 7 SETTING THE TIME AND CORRECTION TIMING MODE - Simple Timing Function START STOP Read time: 5 minutes, 57 seconds, 7/10 sec. Crown in position 1 Correction of hour and minute hand and date at every passing at midnight RESET to zero to order of functions Correction of date and time zone Note: Setting crown in position 3: STOP-SECOND 8 Warning: Before starting the time, put back the chronograph hands to their original position. If necessary, see paragraph Setting the Timers to Zero (page 7). 9 TIMING MODE - Add Function to © order of functions X TIMING MODE - Split Time STOP Read first intermediate time: 1 minute, 57 sec. , 6/10 sec. [. . . ] Battery change should be performed by a qualified technician who should also check the condition of the gaskets and the O-ring at the same time. [. . . ]