User manual VESTAX PMC 40

[. . . ] This makes it possible to output to sampler, rhythm machines, etc'. . , independent of the crossfader. Also this allows normal four channel mixing. 9. The newly designed ROTARY FADER is requested by many of Top DJ's in the world. Perfect control of the curve mode mixing by "curve control" is the first of its kind. 10. 3. [. . . ] Perfect control of the curve mode mixing by "curve control" is the first of its kind. 10. 3. This means a smooth remix can be obtaind. The monitor section has stereo cue for MIC and PGM channels. stereo sound of the source selected button without the fader affecting it. 11. 4. An ALIX assigrr switch on each input module makes good timing and dynamic effect techniques possible. The newly employed CUE OUT provides the by the cue 5. The BEAT INDICATOR functions best effect. I2. HOUSE, /LOUD system allows for three different types of equalizer settings to be set. confirmation of hput signals and assists in BPM adjustment. The mic channel is equipped with 2 band EQ and Pan controls to give the DJ best control. The crossfader is specially 'curved" and has the durability to endure hard scratching. The Vestax is equipped with Vt' jack (unbalanced) and XLR (*4dB balanced) outputs. Therefore the mixer can be matched with any commercial or professional SR systems, ) master output 14. The sub master output can be used for a second or a booth monitor output. B . . . . . . . . . . . . . . . "'To the B (risht) side of the MASTER 13. CROSSFADER Mixes crossfader module requires replacing use Part CF40. When the or changing 26. CUE SELECTOR Used 14. AUX RTN (AUX Input Adjustment Knob) Adjusts the signal level input from an external effector connected to the AUX RTN jacks on the channels 1-4. signals. ?7. to select the stereo cue monitor for PGM mic channel and effect. receive the rear panel. LEVEL (Headphone volume) headphones. Adjusts the monitor level through PHONES (Headphone jack) 150 15. AUX SEND (AUX Output Adjustment Knob) Adjusts the signal level output to an external effector connected to the AUX SEND jacks on the 28. rear panel. NOTE : When the crossfader is used, the sigrral is taken after the crossfader and returned before the master fader. This makes possible a variety of techniques such ag the application of echo to a cut out in which the crossfader would be used. Use this jack to connect the ohm is recommended. headphones, Headphones from 8 ohm to 600 ohm can be used. 29. MAIN MIC (XLR female-pin 3 hot) Input jack of the main mic. SO. PHONO INPUT 35. AUX SEND, /RTN (Vl' Phone Jacks) Connect the SEND jacks to the input L, /R Q4) Input jack for each PGM turntable. external effector unit. (Delay, Reverb etc. ) Connect the RTN jacks to the output of the Connect of an turntables equipped with MM pick up cartridge. effector. STEREO IN, /STEREO OUT effectors or MONO IN, /MONO OUT effectors both can be used. When MONO 3l. LINE INPUT Input connectors for line level equipment such as CD players, tape decks and VTR's. [. . . ] STEREO IN, /STEREO OUT effectors or MONO IN, /MONO OUT effectors both can be used. When MONO 3l. LINE INPUT Input connectors for line level equipment such as CD players, tape decks and VTR's. This helps to reduce noises. L, /E is connected use L terminal. O-8> 36. SUB MASTER OUT 32. of SUB MASTER output jack. [. . . ]