User manual VESTAX PMC-05PROIII

[. . . ] But making them undergone a technology upgrade but it also sports a even more performance friendly is that the curve of new look with a new set of rotary knobs. These new the fader can be preset or adjusted to suit your knobs are built to reduce slippage and improve playing style. The EQ section on the PMC-05ProIII has an improved frequency response of -26dB to +6dB. HOW TO CHANGE INPUT SELECT SWITCH q Remove the top panel in the same procedure. (See fig-a) e Carefully remove the multi-cable connector from the switch unit. [. . . ] switch panel, and remove the switch unit from t Position the switch unit carefully, and secure with position in mixer. (See fig-e) screws. HOW TO CHANGE THE DIRECTION INPUT SELECT SWITCH q Remove the top panel in the same procedure. (See fig-a) w Remove the 2 screws which fix the switch panel, and remove the switch unit from position in mixer. r Replace the top panel and secure with screws. qMAIN MIC LEVEL Adjusts the input level of the MAIN MIC input. wMIC EQs Adjusts the HI and LOW frequencies for both the MAIN and SUB MIC input. eMIC PAN Adjusts the panning for both the MAIN and SUB MIC. rTRIM (PGM1/PGM2) Adjusts the input level of each channel. For optimal acoustic quality, set the INPUT FADER to a position of 7 or 8 then adjust the TRIM so that a sufficient signal is fed through the channel without distorting. tPGM EQs (PGM1/PGM2) Adjusts the HI and LOW frequencies for each PGM channel. yPGM BALANCE (PGM1/PGM2) Adjusts the stereo balance for each PGM Channel. From a center position a clockwise rotation will increase the volume of channel R over L. Whereas, a Counter clockwise rotation will increase the volume of channel L over R. uCROSSFADER REVERSE SWITCH PGM channel. Reverses the action of the crossfader by switching !4 CROSSFADER PGM1 and 2. Reverse mode, when on, is indicated When the input levels of PGM1 and PGM2 are properly in the LED section. set, PGM1 will be heard with the crossfader set to the left iMASTER LEVEL VOLUME side. PGM2 will be heard with the cross fader set to the Adjusts the signal level outputs from LINE OUT. Read instructions-All the safety and operating instructions should be read before the appliance is operated. Retain instructions-The safety and operating instructions should be retained for future reference. Heed Warnings-All warnings on the appliance and in the operating instructions should be adhered to. Follow Instructions-All operating and use instructions should be followed. Attachments-Do not use attachments not recommended by the product manufacturer as they may cause hazards. Water and Moisture-Do not use this product near water-for example, near a dath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, and the like. Accessories-Do not place this product on an unstable cart, stand, tripod, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the appliance. stand, tripod, bracket, or table recommended by the manufacturer, or sold with product. Any mounting of the appliance should follow the manufacturer's instructions, and sholud use a mounting accessory recommended by the manufacturer. This product should never be placed near or over a radiator or heat register. [. . . ] This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. Power sources-This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company. 11. [. . . ]