User manual VESTAX PMC-05PRO3VCA

[. . . ] The product may fall, causing serious injury to a child or adult, and serious damage to the appliance. stand, tripod, bracket, or table recommended by the manufacturer, or sold with product. Any mounting of the appliance should follow the manufacturer's instructions, and sholud use a mounting accessory recommended by the manufacturer. [. . . ] your send and receive signal is easily controlled This full battle worthy layout was designed with a through 2 x volume knobs and the signal can be sent lot of advice from top-level scratch and to PGM1, PGM2 or both simultaneously. The new PMC-05ProIII standard for scratch and performance mixers comes standard with Vestax's latest proprietary since. It is a given that you precise, this plastic conductive volume fader is will punish your mixer enough to need to replace the built to last and survive the most intense play cross fader, an input fader and possibly the input possible. You can easily this new input switch will stand up to just about any replace and or upgrade the faders and the input punishment and is designed to allow quick and switches on the PMC-05Pro series by yourself in constant changing between phono and line inputs. is also omni positional meaning that you can have it Cross Fader Curve Control. Vestax faders have set to its standard position or a number of angles it an undeniably great feel about them. But making them undergone a technology upgrade but it also sports a even more performance friendly is that the curve of new look with a new set of rotary knobs. These new the fader can be preset or adjusted to suit your knobs are built to reduce slippage and improve playing style. The EQ section on the PMC-05ProIII has an improved frequency response of -26dB to +6dB. FUNCTIONS TOP PANEL qMAIN MIC LEVEL Adjusts the input level of the MAIN MIC input. wMIC EQs Adjusts the HI and LOW frequencies for both the MAIN and SUB MIC input. eMIC PAN Adjusts the panning for both the MAIN and SUB MIC. rTRIM (PGM1/PGM2) Adjusts the input level of each channel. For optimal acoustic quality, set the INPUT FADER to a position of 7 or 8 then adjust the TRIM so that a sufficient signal is fed through the channel without distorting. tPGM EQs (PGM1/PGM2) Adjusts the HI and LOW frequencies for each PGM channel. yPGM BALANCE (PGM1/PGM2) Adjusts the stereo balance for each PGM Channel. From a center position a clockwise rotation will increase the volume of channel R over L. Whereas, a Counter clockwise rotation will increase the volume of channel L over R. uCROSSFADER REVERSE SWITCH PGM channel. Reverses the action of the crossfader by switching !4 CROSSFADER PGM1 and 2. Reverse mode, when on, is indicated When the input levels of PGM1 and PGM2 are properly in the LED section. set, PGM1 will be heard with the crossfader set to the left iMASTER LEVEL VOLUME side. PGM2 will be heard with the cross fader set to the Adjusts the signal level outputs from LINE OUT. [. . . ] Once #1 POWER SWITCH Use to turn power on. HOW TO CHANGE THE FADER UNIT q Remove the fader knobs. (See fig-a) e Remove the 2 screws which fix the fader panel, and remove the fader unit from position in mixer. (See fig-b) r Carefully remove the multi-cable connector from the fader unit. t Remove the fader knob of new fader unit. [. . . ]