User manual VESTAX PMC-05PRO3

[. . . ] It is a given that you precise, this plastic conductive volume fader is will punish your mixer enough to need to replace the built to last and survive the most intense play cross fader, an input fader and possibly the input possible. You can easily this new input switch will stand up to just about any replace and or upgrade the faders and the input punishment and is designed to allow quick and switches on the PMC-05Pro series by yourself in constant changing between phono and line inputs. is also omni positional meaning that you can have it Cross Fader Curve Control. [. . . ] A clockwise rotation gives a steep crossfader good for scratching and !5 EFFECT RCV LEVEL cutting, whereas, a counter clockwise rotation gives a Adjusts the signal level input from an external effects unit gentle crossfader good for long running mixes. connected to the EFFECT RCV jacks on the front panel. !0 POWER LED Lights up when the POWER SWITCH is on. !6 EFFECT SEND LEVEL Adjusts the signal level output to an external effects unit connected to the EFFECT SEND JACK on the rear panel. !1 INPUT SELECTOR !2 INPUT FADER (PGM1/PGM2) Used to select the input (LINE or PHONO) to be sent to each PGM channel. !7 EFFECT SEND ON/OFF SWITCH This selector switch can also be used to perform for This switch is used to select the PGM to be sent to TRANSFORMER SCRATCH. To change the operational direction of this !8 MONITOR LEVEL switch remove the top panel and make the necessary the top panel. Adjusts the headphone monitor level. Used to adjust the input level of each PGM channel. fader curve can be changed using a switch located on the unit @0 MONITOR SELECT SWITCH itself. Ensure that you This switch is used to select the signal sent to the monitor replace with an IF-05PCV when it is worn out. When set to CUE the signal heard is determined comprehensive instructions please refer to the "HOW TO by which PGM is being sent to the master and the location CHANGE THE FADER UNIT" section of this user guide. When set to MASTER you !3 INPUT LEVEL METER will hear the master signal in the monitor section. The LED level meters indicate the signal level of each !9 CF MONITOR FRONT PANEL @1 PHONE JACK Connect the headphones with the impedance of 8ohm to 600ohm. @3 EFFECT SEND JACK Connect to the input of the external effects. (Delay, Reverb etc) @2 EFFECT RECEIVE JACK Connect to the output of the external effects. REAR PANEL @4 SUB MIC LEVEL Adjusts the input level from SUB MIC IN. connected, the signal from the turntable is fed to the respective PGM when the Phono Input is selected. @5 MAIN/SUB MIC JACK Input jack for MAIN/SUB MIC. @8 GROUND TERMINAL Connect this terminal to the ground lead of the turntables. @6 LINE INPUT JACK @7 PHONO INPUT JACK These jacks are used to connect line level output @9 POWER JACK devices to the PMC-05proIII. level of -10dB to 0db, such as CD player, MD #0 LINE OUT players, tape decks, DAT players etc. may be The PMC-05ProIII has two pairs of Line Out jacks connected to these jacks. The signal from these sending the same output signal to an external devices is then fed to the respective PGM when Line amplification device. These jacks are used to connect turntables equipped with moving magnet (MM) type cartridges. Once #1 POWER SWITCH Use to turn power on. HOW TO CHANGE THE FADER UNIT q Remove the fader knobs. [. . . ] If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company. 11. Lightning-For added protection for this product during lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet. This will prevent damage to the product due to lightning and power-line surges. [. . . ]