User manual VESTAX PDX-A2S

[. . . ] technician has used a replacement plug specified by the manufacturer that has the same overload protection as the 6. Lightning-For added protection for this product during lightning storm, or when it is left unattended and unused example, near a dath tub, wash bowl, kitchen sink, or for long periods of time, unplug it from the wall outlet. laundry tub, in a wet basement, or near a swimming pool, This will prevent damage to the product due to lightning and the like. Accessories-Do not place this product on an unstable cart, stand, tripod, or table. [. . . ] NON-CENTER-CLICK PITCH FADER Pitch fader has no center click, and it allows delicate adjustment easily. The PDX-a2S features detachable pitch control fader for ease of replacement when it is worn out. MINI LIGHT FOR ILLUMINATING STYLUS he PDX-a2S provides detachable small stylus illuminator for illuminating the stylus tip during play for low-light conditions. OTHER FEATURES Quick stops are achieved with an electronic braking system. Remote control jack is provided for controlling START/STOP by other equipment like a fader start etc. NOTES Before detaching or attaching the headshell, be sure to turn the power of the amplifier or mixer off. Detaching or attaching of the headshell with the volume control turned up may cause damage to the speakers. Do not turn "ON" the power supply, with the turntable platter detached. When play is finished, be sure to secure the tone-arm with the arm clamp. After play is finished, if the unit is not to be used for some time, care should be taken to secure the tonearm to protect the stylus tip. Dust and dirt at the headshell terminals may result in increased "HUM" noise or intermittent sound. Dust and dirt on the stylus tip or record may not only result in deterioration of tone quality, but also cause undue wear of the record and the stylus tip itself. Transportation of the unit to distant places for removal and the like. Pack up the unit in the reverse order to that for unpacking, using the packing materials furnished when the unit was purchased. Should there be no such packing materials, be sure to take the following steps. Remove the turntable platter together with the turntable mat, and wrap it up to prevent any damage to them. Return the tone-arm to the arm rest, and affix it with tape or the like. Remove the balance weight and the headshell/cartridge from the tone-arm and then wrap them up to avoid and damage to them. Wrap up the turntable base with a blanket or soft paper also to prevent any possible damage to it. ACOUSTIC FEEDBACK AND HUM Acoustic Feedback is usually cause by vibration of speaker, which affects the sensitive cartridge. If such a phenomenon occurs, relocate the turntable or speakers as far apart from each other as possible. [. . . ] Push the 45 rpm speed select button if you play 45 rpm record. 7 Move the tone-arm to the armrest when play is finished. 9 Turn off the power. NOTE IN CASE OF PLAYING EP SIZE RECORD Fit the EP ADOPTOR in the center spindle, and start to play after fitting EP RECORDS in EP ADOPTOR. STYLUS ILLUMINATOR (Detachable Mini Light) This unit features a small light for illuminating the stylus. It is detachable and you can remove it when not in use. QUARTZ LOCKED CONTROL AND PITCH ADJUSTMENT 1 When the indicator lamp is lit showing the operating condition for the pre-determined speed (33-1/3 or 45 rpm). 2 During the operation of pre-determined speed, pitch control fader can not be functioned. [. . . ]