User manual VESTAX PCV-275

[. . . ] Always disconnect all equipment from the main supply when disconnecting or reconnecting signal leads. Make sure that the power switch is off when connecting the power cord. [. . . ] This allows DJs to use hand carried DAT or MD player mixing with installed equipment. 1 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTl0N TO REDUCE THE RlSK OF ELECTRlC SHOCK DO NOT REMOVE COVER OR BACK NO USER-SERVICEABLE PARTS INSIDE REFER SERVlCING T0 QUALIFIED SERVlCE PERSONNEL The lighting flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to consitute a risk of electric shock to persons The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance servicing instructions in the literature accompanying the appliance WARNING T0 REDUCE THE RISK 0F FIRE 0R ELECTRlC SHOCK THIS APPLIANCE T0 RAIN 0R M0ISTURE CAUTION DO NOT EXPOSE TO PREVENT ELECTRIC SHOCK, MATCH BLADE OF PLUG TO WIDE SLOT FULLY INSERT ATTENTION P0UR EVITER LES CH0CS ELECTRIQUES INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESP0NDANTE DE LA PRISE ET P0USSER JUSQU AU F0ND IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS WARNING : When using electric products, basic precaution should always be followed, including the following : 1. Do not use this product near water - for example, near a from the outlet when left unused for a long period of time. Care should be taken so that objects do not fall and liquids are bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool, or the like. The product should be serviced by qualified service personnel recommended by the manufacturer. The power - supply cord or the plug has been damaged ; and headphone or speakers, may be capable of producing B. Objects have fallen, or liquid has been spilled into the sound levels that could cause permanent hearing loss. Do not product ; or operate for a long period of time at a high volume level or at a C. The product has been exposed to rain ; or level that is uncomfortable. Do not attempt to service the product beyond that described in with its proper ventilation. The product should be located away from heat sources such as be referred to qualified service personnel. The product should be connected to a power supply only of the type described in operating instructions or as marked on the product. 2 FUNCTIONS TOP PANEL MICROPHONE AND SUBINPUT SECTION PROGRAM INPUT SECTION MASTER SECTION LINE 4 IN L R PGM 1 INPUT PHONO 1 LINE 2 SUB INPUT PHONO 2 LINE 4 PGM 2 INPUT PHONO 3 LINE 6 MASTER +8 +5 +8 +5 +3 +1 0 -1 -3 -5 -7 -10 -15 POWER CUE MIC TRIM +3 LINE 1 LINE 3 LINE 5 +1 0 TRIM TRIM -1 -3 MIC-1 MIC-2 MIN MAX MIN MAX MIN MAX -5 -7 -10 -15 POWER MIC-1 BAL BAL BAL MIN MAX L R L R L R MIC-2 EQ HI EQ HI EQ HI L R EFFECT SEND MIN MAX -16dB +16dB -16dB +16dB -16dB +16dB EQ HI MID MID MID MIN MAX RETURN -16dB +16dB -12dB +12dB -12dB +12dB -12dB +12dB LO LO LO LO MIN MAX CUE -16dB +16dB -16dB +16dB -16dB +16dB -16dB +16dB OFF ON EFFECT OFF POST EFFECT EFFECT EFFECT MASTER PRE OFF POST PRE OFF POST PRE OFF POST BAL CUE OFF ON CUE OFF SIGNAL ON CUE OFF SIGNAL ON CUE OFF SIGNAL ON L R LEVEL LEVEL 10 9 8 7 6 5 4 10 9 8 7 6 5 4 3 2 1 0 LEVEL 10 9 8 7 6 5 4 3 2 1 0 LEVEL MIN MAX MONITOR SPLIT CUE ON OFF PHONES LEVEL ISOLATOR SECTION 3 2 1 0 MIN MAX PHONES IN PGM1 ISOLATOR PGM2 ISOLATOR LO MID HI 1 2 LO MID HI PHONES IN 8 3 PROGRAM INPUT SECTION PGM 1 INPUT PHONO 1 LINE 2 1 2 INPUT SELECTOR Used to select input (2 line or 1 phono) to be sent to each PGM channel. 1 2 MIN TRIM CONTROL Adjusts the Input level of each channel. adjust TRIM so that the INPUT LEVEL METER shows about 0dB. LINE 1 3 MAX BALANCE CONTROL Adjusts the stereo balance for each PGM channel. [. . . ] The signal is selected by the effect switch. 15 -1 -3 -5 -7 -10 -15 POWER 18 EFFECT RETURN LEVEL Used to adjust the input level from the EFFECT RETURN JACK. This EFFECT RETURN can be used as the sub line input. L R EFFECT SEND 19 EFFECT CUE SWITCH Used to send the signal from EFFECT RETURN JACK to the monitor section for headphone monitoring. 17 MIN MAX RETURN 20 MASTER BALANCE VOLUME Adjusts the signal balance of left to the right side of the outputs from the OUTPUT jack on the rear panel. 18 MIN MAX 19 20 CUE OFF ON 21 22 MASTER LEVEL VOLUME Adjust the signal level output from the output jack on the rear panel. MASTER BAL SPLIT CUE SWITCH When this switch is ON, the master signal is always heard through the right earcup of the headphone. [. . . ]