User manual VERBATIM WIRELESS TRAVEL MOUSE WITH 5-BUTTONS

[. . . ] Use of 256 ID codes to prevent interference between several wireless mice being used simultaneously 3. Mouse includes 5 Buttons and software for user defined actions to 3 of these buttons System Compatibility Win 95/98/Me/2000/XP Initial Set up 1. [. . . ] To turn the mouse power on push the ID button, as indicated by Figure 3 below, for 3 seconds or more until the light comes on Figure 3 User-Defined Buttons Software Setup This product includes software to allow the end user to define actions to 3 of the buttons. Figure 4 below describes the buttons which can be defined. Figure 4 1. If the program does not start automatically, open the folder titled "Mouse" on the disc and run the file called "setup. exe" 3. The program will start to run as follows; · Click "next" button · · Select the " 5 Button Mouse" option Click " Next" · Accept the default destination directory and click " Next" · Accept the " Program Folder" and click " Next" · When setup is completed restart the computer Defining Buttons · · After the computer is reset the following icon appears in the taskbar. Double click this icon to edit the button functions · Select the " Button" setting · Note: Select the function you would like to define for each button 3, 4 and 5 1. Please remove the batteries if the mouse will not be used for an extended period of time 2. If the mouse has entered power sleep mode please press any mouse button or move the mouse to make it active again 3. To turn the mouse power off click on the ID button on the underside of the mouse for over 3 seconds until the light turns off 4. Optical mouse will not operate correctly on any reflecting surface such as glass or 3D mouse pads Caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: * * * * Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ]