User manual VERBATIM EXTERNAL HARD DRIVE USB 2.0

[. . . ] Rechargeable batteries can be recharged by connecting the mouse to the computer USB port using the supplied USB cable System Compatibility Win 95/98/Me/2000/XP Macintosh 9. x, 10. x Initial Set up 1. [. . . ] Click the ID button at the end of the receiver once, (See Figure 1 below). Next, click the ID button on the underside of the mouse as indicated in Figure 1 Figure 1 7. The red light on the receiver will flash rapidly for a few seconds then stop flashing 8. To turn the mouse power on push the ID button, as indicated by Figure 3 below, for 3 seconds or more until the light comes on Figure 3 Receiver Storage The USB receiver is stored on the underside of the mouse. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: * * * * Reorient or relocate the receiving antenna. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: * * * * Reorient or relocate the receiving antenna. [. . . ]