User manual VAX RAPIDE DELUXE

[. . . ] Note: use only VAX AAA cleaning solution, using other cleaning solutions may cause excessive foaming. Place the bottom of the solution reservoir into the cleaner and push into place. There will be an audible click when the reservoir is in the correct position. How to operate your cleaner Important: Never leave the cleaner unattended with the power on. Vacuum carpets thoroughly with dry vacuum cleaner before washing. 7 8 9 10 Plug the cord into a mains electricity socket. [. . . ] Tipping the cleaner and breaking the seal of the nozzle against the carpet will cause the float to rise cutting off suction. If the tank does not appear full, turn off the power switch and wait for the float to settle. For best results use only Vax AAA cleaning solution. 1 2 3 13 You will hear a distinct change in the noise coming from your cleaner when the tank is full and needs emptying. Grasp the top of the dirty water tank handle and press the release latch. Grasp the handle and pull up out of the base, take care to ensure that no dirty water leaks from the front. Remove dirty water tank lid. Emptying the dirt water tank Cleaning the dirty water tank Replacing the dirty water tank 6 4 5 14 To empty the water tank grasp the handle with one hand and the nozzle with the other and empty into the sink. Rinse the dirty water tank and filter thoroughly with warm water. You should allow them to dry fully before replacing them on your cleaner to prevent mildew. Do not use any chemicals in the cleaning process. Lift the front of the carpet cleaner base off the carpet with one hand. Emptying the dirty water tank 7 8 15 Grasp the handle and hook the front of the dirty water cleaner into the base, making sure that the front of the dirty water tank is resting on the base. The dirty water tank has three tabs on the underside which MUST latch on to the underside of the base of the cleaner. The base must be lifted so that the nozzle is flush with the base of the cleaner. Failure to install the dirty water tank correctly will result in poor dirty water pick up. While making sure the dirty water tank is resting on the base, place the rear of the tank into the base of the cleaner, push down on the handle until it latches. Empty and rinse clean the water tank after use. Belt or brush removal and replacement Phillips screwdriver required The plug must be removed from socket outlet before cleaning or maintaining the appliance. 1 2 3 16 Remove the water tank switch off and unplug the carpet washer. Flip the cleaner on it's side to expose the nozzle base. To remove the belt cover, use a phillips screwdriver to remove the two screws. Grasp the belt cover near the belt roll and lift out. Belt or brush removal and replacement 4 5 6 17 Grasp the brush bar with one hand, using the other hand to keep tension on the the belt while removing. Lift up while you're pulling it out Slide the belt off the the motor shaft and dispose. Belt or Brush removal and replacement Phillips screwdriver required 7 8 18 When replacing the belt, first slide it onto the motor shaft. Slide the brush bar into the nozzle, ensuring that the brush bar end caps are orientated correctly, see inset picture. Manually turn the brush bar to check that it is fitted properly. Replace the belt cover by inserting the end furthest from the brush first. Then replace the front of the belt cover before securing in place with the two screws. Troubleshooting Problem Cleaner won't run Possible Cause · Power cord not firmly pushed into a mains socket. [. . . ] · Do not use without the solution reservoir and dirty water tank in place. · Do not use to pick up flammable or combustible liquids such as petrol, or use in areas where they may be present. · Do not attempt to remove blockages with sharp objects as they may cause damage. · Using improper voltage may result in damage to the motor and possible injury to the user. [. . . ]