User manual VALERA X MASTER

[. . . ] Do not remove the plug from the mains power socket by pulling the cable. €Do not pull the plug out of the power supply socket when your hands are wet. €Before switching on the appliance, always check its conditions and also control the transformer and power cable. €The elements used to pack the unit (plastic bags, cardboard box, etc. [. . . ] €When the battery is fully discharged, the appliance automatically switches off. 03 •Only recharge the battery when you note a clear reduction in appliance power. €When the battery is fully discharged, the appliance automatically switches off. RECHARGING THE BATTERY •Before using the appliance for the first time, charge the battery for 3 hours (Type 652. For subsequent charges, allow the appliance to charge for at least 2, 5 hours (Type 652. 02: while charging the battery, the 4 green LEDs indicate the charge level reached. Recharging), the appliance is ready to operate in cordless mode up to 70 min. When reaching this charge level, the appliance is ready to operate in cordless mode up to 70 min. €When the battery is fully charged, the appliance can be used up to 110 minutes without connection to the mains. €After a certain number of operating hours, charge duration in cordless mode may decrease significantly. €The maximum charge level is reached after 4 - 5 recharging procedures. ADJUSTING THE CUTTING LENGTH The appliance is equipped with the VARIO-CUT SYSTEM, which allows the selection of 5 different cutting lengths (fig. CUTTING WITH GUIDE COMBS Depending on the type of cut desired, the appliance can be used with or without a guide comb (fig. Guide combs are used to achieve different cutting lengths ranging from 4 to 20 mm. €To remove the blades, push them out of their slot from underneath (fig. €IMPORTANT: before fitting the blade, make sure that the motor pin (fig. 1) is adjusted so that it can slot into the space on the inner side of the blade (fig. 6) has a compartment where part of the cable can be wrapped if the full length is not required (fig. CARE AND MAINTENANCE The cleaning and maintenance procedure must be carried out after every use. €Switch OFF the appliance and disconnect it from the mains supply before performing any maintenance or changing any parts. [. . . ] All other claims of any nature, including those for eventual damages outside of the appliance, are excluded, unless our liability is legally mandatory. The guarantee service is carried out free of charge; it does not affect the expiry date of the guarantee. The guarantee becomes void if repairs are undertaken by unauthorized persons. For UK only: this guarantee in no way affects your rights under statutory law. [. . . ]