User manual UNIVERSAL ELECTRONICS URC-4140

[. . . ] Device keys The TV, VCR/DVD, SAT and AUX keys select the device to be controlled. For example pressing the TV key allows the remote to control the functions of you Television, after pressing the VCR/DVD key you can operate your Video Recorder or DVD Player, the SAT key operates your Satellite Receiver or Cable Converter etc. Power key The Power key controls the same function as on your original remote. [. . . ] Press and release the TV key on your TOTAL CONTROL. TV 2 3 Press and hold down the SET key until the red light blinks twice (the red light will blink once and then twice). If your television switches off, your TOTAL CONTROL should be ready to control your television. SET P 4 ____ POWER 5 - If your device does not respond, follow steps 1 through 5 with each code listed for your brand. If none of the codes listed for your brand operate your device, then try the Search Method described on page 7, even if your brand is not listed at all. If your device does not respond or is not functioning properly with one of the codes, try another code listed under your brand. - If the original remote control from your Video Recorder did not have a Power key, press PLAY instead of POWER during step 5. - To set up your other devices, follow the same instructions above, only press the appropriate device key during step 2. - Write your code in the boxes provided in the battery compartment and on page 8, for quick, easy reference. Devices can be found under the following keys: Television SatelliteReceiver / CableConverter SAT POWER Video Recorder/ DVD VCR/ DVD TV AUX (*) Television (*) Video Recorder/ DVD (*) SatelliteReceiver / CableConverter - To set up a second TV, VCR/DVD or SAT see page 9. - (*) To use the AUX key see page 9. 6 The Search Method If your device does not respond to the TOTAL CONTROL after you have tried all the codes listed for your brand, try the Search Method. Example: to search for your Television Code: 1 2 3 Switch your Television on (not on standby). Press and hold down the SET key until the red light on the TOTAL CONTROL blinks twice. Press 9 9 1, the red light will blink twice. 9 9 TV SET P 4 5 1 Now alternate between the TV and POWER key, over and over, until your Television turns off. You may have to press these keys many times (up to 150 times) so please be patient. Remember to keep pointing the TOTAL CONTROL at your Television when pressing these keys. TV POWER 6 When your Television switches off, press the SET key to store the Code. Now, your TOTAL CONTROL should be ready to control your television. SET P - If you cannot control your Television properly, please continue the Search Method, you may be using the wrong Code. - To search for your other devices, follow the same instructions above, only press the appropriate device key during step 2 and 5. - If your Video's original remote control does not have a POWER key, press PLAY instead of POWER when searching for your Code during step 5. 7 Blink out the Current Code If you have set up your TOTAL CONTROL via the Search Method, you can blink back your code for future reference. [. . . ] Some countries do not allow the exclusion or limitation of incidental or consequential damages, or limitation on how long an implied warranty lasts, so the above exclusions or limitations may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from country to country. To obtain warranty service during the warranty period, please carefully pack the product and send it prepaid and adequately insured to the address below, together with your purchase receipt or other proof of the date of original purchase. [. . . ]