User manual UNITED OFFICE KH 4418 LAMINATOR

[. . . ] â· Never perform hot lamination on flammable, heat-sensitive and/or meltable materials and do not laminate drawings on temperature-sensitive paper or material that will undergo changes in colour or quality when subjected to heat. Although the laminator satisfies all predominant safety norms and standards, errors can never be completely discounted - as with all electrical appliances. Errors with the laminator can result in damage to the document being laminated. Do NOT laminate any document which, together with the laminating pouch, would have a thickness of more than 1, 0 mm. [. . . ] Pull the document support s out, so that the document can be pulled in straight into the slot for manual pouch input t. Lay the document to be laminated into a laminating pouch of the appropriate size. Make certain that all corners of the document have at least two millimetres of space to the edge of the laminating pouch, as shown in Fig. The laminator has reached its operating temperature as soon as the green LED indicator light "Ready" u glows. attainment of the operating temperature is indicated by the lighting up of the green LED indicator lamp "Ready" u. For a more uniform laminating result we recommend, especially for thinner foils (below 125 Micron) and after adjustment to a different foil thickness, to first wait an additional 2-3 minutes before beginning with lamination. The red ON / OFF indicator lamp y and the green indicator lamp "Ready" u now glow. Lay the document to be laminated into a laminating pouch of the appropriate size. Make certain that all corners of the document have at least two millimetres of space to the edge of the laminating pouch, as shown in Fig. If you have previously performed hot lamination: After hot laminating, allow the laminator to cool down completely before beginning with cold lamination. Pull the document support s out, so that the document can be pulled in straight into the slot for manual pouch input t. Lay the right or left edge of the laminating pouch against the pouch format lock r (closed side leading). Slide the pouch format lock r together until the selected format size is reached. Should the laminating pouch be pulled in at an angle, use the "Anti-Blocking Funktion" as described in chapter 11. Now slide the laminating pouch slowly into the When you have slid the laminating pouch several Centimetres into the slot t, it will start to be pulled in automatically. Release the laminating pouch as soon as you notice it being pulled in automatically. Ensure there is at least 30 cm of open space in front of the laminator. If you do not, the laminating pouch will not be completely ejected from the laminator after lamination. Turn the anti-blocking switch (ABS) o back to the desired foil thickness. Should you wish to use the trimming function on the pouch guide q, dismantle the pouch guide q. Only after hot lamination: When the finished laminated pouch is discharged from the pouch ejector slot a of the appliance, it is hot and can easily change its shape. For this reason, allow the laminated pouch to cool down for at least one minute before touching it. [. . . ] The warranty for this appliance is for 3 years from the date of purchase. The appliance has been manufactured with care and meticulously examined before delivery. In the event of a warranty claim, please make contact by telephone with our Service Department. The warranty covers only claims for material and maufacturing defects, but not for transport damage, for wearing parts or for damage to fragile components, e. [. . . ]