User manual UNIDEN TXC400

[. . . ] This additional handset is for use with the Uniden TRU446, TRU448, TRU4465, TRU4485, or TRUC46 (Card Phone) base. You can place a fully featured cordless handset anywhere in your home where AC power is available to connect the handset charger. The original base will support up to 2 handsets (the original handset and one TXC400 handset). The TXC400 will not be an alternative of the original handset, if the original handset is damaged. Important The TXC400 will not operate unless it has been registered to a Uniden TRU446, TRU448, TRU4465, TRU4485, or TRUC46 (Card Phone). [. . . ] If the phone is in use, "Low Battery" appears and the handset beeps. Complete your conversation as quickly as possible and return the handset to the base unit for charging. Cleaning the battery charging contacts To maintain a good charge, it is important to clean the battery contacts on the handset and base unit with a dry cloth or a pencil eraser about once a month. Do not use any liquids or solvents. Connect the Charger 1 2 Connect the AC adapter to the DC IN 9V jack and to a standard 120V AC wall outlet. Set the charger on a desk or tabletop, and place the handset in the charger with the keypad facing forward. contacts 3 Make sure that the charger LED illuminates. If the LED does not illuminate, check to see that the AC adapter is plugged in and that the handset makes good contact with the base charging contacts. · Place the charger close to the AC outlet so that you can unplug the AC adapter easily. · "HS2" appears on the display while the handset is charging. Polarity of the plug ­4­ Register the Handset You need to register the TXC400 before use. To register the additional handset, do the following steps in compliance with your original unit. For TRU446/TRU4465/TRU448/TRU4485 unit Place the TXC400 handset on the original unit's base until you hear a confirmation tone. If the original base is mounted, you will need to hold the handset to the base until the status LED on the unit's base is illuminated. · If the original base is a TRU448, to register the TXC400, place the TXC400 on the TRU448 base with the keypad facing down. · If you did not hear the confirmation tone, register the TXC400 again. · In some cases you may need to attempt registration a few times. For TRUC46 (Card Phone) unit 1 2 3 Unplug the AC adapter of the TRUC46. Press and hold PAGE on the TRUC46 base, while you plug in the AC Adapter, until the status LED on the base flashes. When the operation is finished, you will hear a confirmation tone and "Registration Complete" will appear. · If the registration fails, "Registration Failed" appears. · You must complete the registration operation within 30 seconds, or the phone returns to the standby mode. If you changed the digital security code of the original unit: You need to perform the following steps: code 1 De-register the digital securityDigital of the TXC400. (For instructions, see "Change the Security Code" in the owner's manual supplied with the original unit. 2 Register the TXC400 to the original base by following the steps above. ­5­ Call Transfer Feature You can transfer an outside call to the original unit. For more instructions, see the owner's manual supplied with the original unit. To transfer a call to the original unit To receive a transferred call from the original unit To cancel the transfer Press xfer/del during a call. When the original unit receives the transfered call, the TXC400 handset returns to the standby mode. [. . . ] Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owner's manual you are certain that the Product is defective, pack the Product carefully (preferably in its original packaging). The Product should include all parts and accessories originally packaged with the Product. [. . . ]