User manual UNIDEN TCX800

[. . . ] This manual describes how to set up and connect your new handset; for instructions on operating your new handset, refer to the owner's manual that supplied with your main base unit. To purchase additional handsets (TCX800), visit our web site at www. uniden. com. Checking the Package Contents Make sure you have received the following items in the package. If any of these items are missing or damaged, contact the Uniden Parts Department. · Cordless Handset · Charging Cradle · Battery Pack (BT-446) (Capacity: 800 mAH, 3. 6V) · AC Adapter (AD-0005) (INPUT: 120V AC 60Hz) (OUTPUT: 9V DC 210 mA) · Beltclip · This Owner's Manual · Other Printed Material Uniden Parts Department at (800) 554-3988 Hours: M-F 8:00 a. m. [. . . ] With the main base in standby mode (i. e. , not being used), place the extra handset in the main base unit to begin registration. While the handset is registering, Ha nd s et R eg i st e ri n g will appear in the LCD. When Registration C om p le t e is displayed, the handset has been registered to the base. If R eg is t ra t io n F a il ed appears, please try these steps again. 1 TCX800 Handset Charger Charge the handset for 15-20 hours. 2 TCX800 Handset Place the TCX800 handset in the main base to register. Main Base TCX800 Handset 3 Main Base + ­4­ Using Your Expansion Handset Now the your new handset is registered, it can perform all the same functions as the handsets originally included with your phone. With your new handset, you can · Transfer calls between handsets · Use two handsets as walkie-talkies in DirectLink mode · Use two handsets as a baby/room monitor · Hold 3- or 4- conference calls (depending on model) · Access your main base's integrated answering device (if available) See the owner's manual that came with your main base unit for complete instructions on operating your new expanded digital phone. Battery Information Low battery alert When the batteries are very low and need to be charged, the phone is programmed to eliminate functions in order to save power. The batteries need to be charged when: - The empty battery icon appears. If you are on a call, complete your conversation as quickly as possible, and return the handset to the charging cradle. Cleaning the battery charging contacts To maintain a good charge, it is important to clean the charging contacts on the handset once a month. Then make sure to go back over the charging contacts with a dry cloth before returning the handset to the charger to charge. Caution: Do not use paint thinner, benzene, alcohol, or other chemical products. Doing so may discolor the surface of the telephone and damage the finish. ­5­ I. C. Notice TERMINAL EQUIPMENT NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications. The abbreviation, IC, before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is marked on the equipment itself. The REN assigned to each terminal equipment provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed five. RADIO EQUIPMENT The term "IC:" before the radio certification number only signifies that Industry Canada technical specifications were met. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. "Privacy of communications may not be ensured when using this telephone. " As an Energy Star Partner, Uniden has determined that this product or product models meets the Energy Star guidelines for energy efficiency. THE FCC WANTS YOU TO KNOW Changes or modifications to this product not expressly approved by Uniden, or operation of this product in any way other than as detailed by the owner's manual, could void your authority to operate this product. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Uniden works to reduce lead content in our PVC coated cords in our products and accessories. [. . . ] PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owner's manual you are certain that the Product is defective, pack the Product carefully (preferably in its original packaging). The Product should include all parts and accessories originally packaged with the Product. Include evidence of original purchase and a note describing the defect that has caused you to return it. The Product should be shipped freight prepaid, by traceable means, to warrantor at: Uniden America Corporation Parts and Service Division 4700 Amon Carter Blvd. [. . . ]