User manual UNIDEN PC78XL

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual UNIDEN PC78XL. We hope that this UNIDEN PC78XL user guide will be useful to you.


UNIDEN PC78XL : Download the complete user guide (394 Ko)

Manual abstract: user guide UNIDEN PC78XL

Detailed instructions for use are in the User's Guide.

[. . . ] If there is no response, select an active channel and ask that party to relay your emergency broadcast on Channel 9. All channels, except Channel 9 may be used for normal communication. Channel 9 is reserved by the FCC for emergency communications involving the immediate safety of individuals or protection of property. Channel 9 may also be used to render assistance to a motorist. This is an FCC rule and applies to all operators of CB radios. 1 pc78xl. qxd 2/25/99 10:09 AM Page 2 Controls and Functions FRONT VIEW - PC78XL BACKLIGHTED PANEL 1. SWR CAL: Calibrates the meter for Standing Wave Ratio (SWR) measurements. [. . . ] Your Uniden dealer is qualified to help you select the proper antenna for your requirements. A short `loaded' whip antenna is easier to install on an automobile. However, the efficiency of the short whip antenna is less than that of a full quarter-wave whip antenna. MARINE INSTALLATION Consult your dealer for information regarding marine installation. It is important to adequately ground the system and to prevent electrolysis between the fittings in the hull and the water. 4 pc78xl. qxd 2/25/99 10:09 AM Page 5 CONNECTING THE POWER CORDS We recommend connecting the power lead to the Ignition Switch Accessory Terminal. This way, the transceiver is automatically turned off when the ignition switch is turned off. Or, the power cord may be connected to an available terminal on the fuse block, or, to a point in the wiring harness. If in doubt, contact your vehicle dealer for information. GROUND INFORMATION This transceiver may be installed and used in any 12volt DC negative or positive ground system vehicle. and foreign made cars, and small trucks, use a negative ground system. Some older cars, and some new large trucks, use a positive ground system. With a negative ground system, the negative (-) battery terminal is usually connected to the vehicle motor block. If you cannot determine the polarity system of your vehicle, contact your vehicle dealer for information. Negative Ground System If you have a negative ground system, connect the red DC power cord from the transceiver to the positive (+) battery terminal or other convenient point. Then connect the black power cord to the vehicle chassis or negative (-) battery terminal. Positive Ground System If you have a positive ground system, connect the black DC power cord from the transceiver to the negative (-) battery terminal or other convenient point. Then, connect the red power cord to the vehicle chassis or the positive (+) battery terminal. 5 pc78xl. qxd 2/25/99 10:09 AM Page 6 To Receive Be sure that the power source, antenna, and microphone are properly connected before proceeding. Set switch to NB/ANL. Dynamic Squelch Control automatically sets Squelch to the optimal level for stronger transmission and signal clarity. To scan for weaker signals, turn off Dynamic Squelch Control and perform the following steps: 4. Set SQUELCH only when the radio is not receiving a strong signal. 6 pc78xl. qxd 2/25/99 10:09 AM Page 7 5. Adjust RF GAIN knob (small) to optimize reception in strong signal areas. 6. Adjust DELTA TUNE knob to reduce or eliminate adjacent channel interference. 7. Set meter switch to S/RF To Transmit Perform a voltage Standing Wave Ratio (SWR) measurement prior to using the transmitter. A SWR ratio in excess of 2:1 may damage the transmitter Be sure to read and understand Part 95, FCC Rules and Regulations before operating your transmitter. When the channel is clear, press the microphone PTT switch and speak. 7 pc78xl. qxd 2/25/99 10:09 AM Page 8 Multi-Function Meter SWR Meter: Measures SWR (standing wave ratio) of antenna. Use it to check the antenna system or to adjust your antenna to the proper length. [. . . ] THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION OF LAW, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE UNIDEN PC78XL




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual UNIDEN PC78XL will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.