User manual UNIDEN GMRS480 REFERENCE GUIDE

[. . . ] When the Memory feature is turned on, the menu is automatically expanded to enable memory programming [refer to the User Programming Menu]. Advance through the menu until the SAVED icon on the display is shown. 3) If on is selected, press menu/select to advance to the Memory Programming menu. When you pass location 10 an E will flash indicating that you can press menu/select to exit the menu. [. . . ] 3) Place the pack in the compartment, paying close attention to the round alignment key. If the pack is installed incorrectly, the unit will not operate and the compartment door will not close properly. 5) The battery pack must be charged before using it for the first time. Insert the charger adapter into the accessory jack and allow 12-14 hours charging time to fully charge the battery pack. Choosing a CTCSS Code Each of the GMRS/FRS channels 1-15 may have any one of the codes 0-38 selected. Code "0" indicates no CTCSS code selected and your radio can receive a signal regardless of the code settings of the transmitting radio. Advance through the menu, the CTCSS code on the LCD display will flash. 2) Press the v or w button to increase or decrease the code number displayed. 3) Exit the menu to return to "normal" mode. THANK YOU Channel Scan Feature Your GMRS480 radio has a channel Scan feature that allows you to easily scan all 15 channels. When an active channel is detected, the unit will pause on that channel until the channel is clear. Pressing PTT while the scan is paused on a channel will allow you to transmit on that channel. To turn on channel scanning: Press and hold either the v or w button until the icon appears on the display. The channel number on the display will rapidly cycle through the channels. To turn off channel scanning: Press and release the v or w button. Turning the Radio On and Adjusting the Volume 1) Rotate the on/off/volume control clockwise to turn the unit on and increase the speaker volume. 2) Rotate the on/off/volume control counterclockwise to decrease the speaker volume and turn the unit off. Talking on Your Radio To talk to others using the radio: 1) Press and hold the PTT button and speak in a clear, normal voice about 2-3 inches away from the microphone. To avoid cutting off the first part of your transmission, pause slightly after pressing the PTT button before you start talking. While receiving, the icon will appear on the display. Keypad Lock To lock the keypad, press and hold the WX/lock button until the icon is displayed. To remove the keypad lock, press and hold the WX/lock button until the icon disappears. 1 Antenna 2 Monitor Button 3 PTT Button 4 Up Key 5 Down Key 6 Menu/Select Key 7 Microphone 8 Speaker 9 On/Off/Volume Control 10 Beltclip 11 Headset Jack 12 Weather/Lock Key 13 Call Key 14 Battery Cover 15 Weather Indicator 16 Receive Indicator 17 Transmit Indicator 18 Battery Level Meter 19 Scan Indicator 20 Channel Indicator 21 Vibrate Indicator 22 Memory Operation Indicator 23 Call Alert 24 Temperature Reading 25 Lock Indicator 26 CTCSS Code Adjusting the Sound (Key Beeps) Your radio emits a beep each time one of the buttons is pressed. To turn this sound on, press menu/select while turning on the radio. Ambient Temperature Display Your radio will periodically display the ambient temperature either in degrees F° or degrees C°. The letters F or C will be blinking indicating the selection. Navigating through the Menu To access the advanced features of the GMRS480, your radio has a menu function. 2) Press either the v or w button to toggle between F or C. Note: Once the radio is turned on, please allow time for an accurate temperature reading to be collected. Channels CTCSS Codes Operating Frequency Power Source SPECIFICATIONS 8 GMRS/7 FRS, 7 Weather 38 Sub-Audible Tones UHF 462. 550- 462. 725 MHz VHF 162. 400-162. 550 MHz 6V NiMH Battery Pack 4 AA Alkaline Batteries 2W ERP maximum 10 Hours - NiMH Battery Pack (5/5/90 duty cycle) 35 Hours - Alkaline Batteries FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: ·This device may not cause harmful interference. [. . . ] THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OVERPAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owner's manual you are certain that the Product is defective, pack the Product carefully (preferably in its original packaging). [. . . ]