User manual UNIDEN GMR325-2 REFERENCE GUIDE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual UNIDEN GMR325-2. We hope that this UNIDEN GMR325-2 user guide will be useful to you.


UNIDEN GMR325-2 REFERENCE GUIDE: Download the complete user guide (526 Ko)

Manual abstract: user guide UNIDEN GMR325-2REFERENCE GUIDE

Detailed instructions for use are in the User's Guide.

[. . . ] To turn OFF channel scanning: Press either the channel/scan L or M key. Note: If you press either the channel/scan L or M key while the unit is pausing on a channel, scanning will resume. Talking on Your Radio To talk to others using the radio: 1) Press and hold the PTT button and speak in a clear, normal voice about 2-3 inches away from the microphone. To avoid cutting off the first part of your transmission, pause slightly after pressing the PTT button before you start talking. [. . . ] 467. 6625 467. 6875 467. 7125 462. 5500 462. 5750 462. 6000 462. 6250 462. 6500 462. 6750 462. 7000 462. 7250 15 GMRS / 7 FRS UHF 462. 5500467. 7125 MHz 3 AAA Alkaline Batteries (not included) 500mW Conducted 25 Hours typical (5/5/90 duty cycle) USING THE RADIO In order to get the most out of your new radio, read this reference guide completely before attempting to operate the radio. Turning the Radio On and Adjusting the Volume 1) Press and hold the key to turn the radio ON. 2) To change the volume level press the volume/monitor L or M key to increase or decrease the volume level. Adjusting the Sound (Key Beeps) Your radio emits a beep each time one of the keys (except for the PTT button and call key) is pressed. The sound of the Key Beep will increase or decrease depending on the volume level setting. 1 2 3 4 5 6 7 8 9 Antenna PTT (Push-To-Talk) Button Channel/scan up Key Channel/scan down Key Call Key Speaker Power On/Off Key Volume up/mon (monitor) Key Volume down/mon (monitor) Key 10 11 12 13 14 Microphone Channel Indicator Receive Indicator Battery Level Indicator Transmit Indicator FCC INFORMATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Important: Changes or modifications to this unit not expressly approved by Uniden could void your authority to operate this unit. Your radio is set up to transmit a regulated signal on an assigned frequency. It is against the law to alter or adjust the settings inside the radio to exceed those limitations. · Never change or replace anything in your radio except the batteries. Your radio might cause TV or radio interference even when it is operating properly. To determine whether your radio is causing the interference, turn it off. Try to eliminate the interference by moving your radio away from the receiver. If you cannot eliminate the interference, the FCC requires that you stop using the radio. Hazardous Environments: Do not operate the radio in hazardous environments. Under certain conditions, radios can interfere with blasting operations and may cause an explosion. Turn your radio OFF to prevent accidental transmission when in a blasting area or in areas posted: "Turn off two-way radio. " Construction crews often use remote control RF devices to set off explosives. Care and Safety: To clean the radio, use a soft cloth dampened with water. Do not use cleaners or solvents because they can harm the body of the unit and leak inside, causing permanent damage. If the unit gets wet, turn it off and remove the batteries immediately. Dry the battery compartment with a soft cloth to minimize potential water damage. [. . . ] WARRANTOR: UNIDEN AMERICA CORPORATION ("Uniden") ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below. WARRANTY DURATION: This warranty to the original user shall terminate and be of no further effect 12 months after the date of original retail sale. The warranty is invalid if the Product is: (A) damaged or not maintained as reasonable or necessary, (B) modified, altered, or used as part of any conversion kits, sub-assemblies, or any configurations not sold by Uniden, (C) improperly installed, (D) serviced or repaired by someone other than an authorized Uniden service center for a defect or malfunction covered by this warranty, (E) used in any conjunction with equipment or parts or as part of any system not manufactured by Uniden, or (F) installed or programmed by anyone other than as detailed by the owner's manual for this product. STATEMENT OF REMEDY: In the event that the product does not conform to this warranty at any time while this warranty is in effect, warrantor will either, at its option, repair or replace the defective unit and return it to you without charge for parts, service, or any other cost (except shipping and handling) incurred by warrantor or its representatives in connection with the performance of this warranty. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE UNIDEN GMR325-2




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual UNIDEN GMR325-2 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.