User manual UNIDEN GMR2889-2CK

[. . . ] GMR2889-2CK · 15 GMRS / 7 FRS Channels · 142 Privacy Codes (CTCSS Tone and DCS Code) · Up to 28 Mile Range* · Direct Call · 143 Group Codes · Silent Mode · Internal VOX Circuitry · 10 Selectable Call/Ring Tone Alerts · Backlit LCD Display · Optional Headset Accessories · Headset Jack · Roger Beep · Power Boost Button for Maximum Range · All Call · Auto Channel Change Call · Battery Charger · Battery Level Meter · Channel Monitor · Channel Scan · Group Scan · Keypad Lock · NOAA Emergency / Weather Channels · Emergency Weather Alert · DC IN 9V Jack Congratulations on your purchase of the Uniden GMR2889-2CK (General Mobile Radio Service) radio. This lightweight, palm-sized, radio is a stateof-the-art device, equipped with many valuable features. Use it at sporting events, to stay in contact with family and friends, hiking, skiing, outdoors, or in a neighborhood watch for vital communication. 3) Put the NiMH battery pack in the battery compartment applying the battery contacts to the lower charge contacts. Be sure to follow the instructions written on the battery pack's label. [. . . ] The range of channels 1-7 and 15-22 can be boosted only when you use NiMH batteries. When you press Power boost while using alkaline batteries, the range is not boosted. Setting the Radio to Group Mode To set the radio to Group Mode, which enables Direct Call, Auto Channel Change and All Call, press and hold menu/grp for 2 seconds. Press L to display on GRUP, then press menu/grp to advance to setting the Group Code. Note: In group mode, you cannot receive transmissions from other radios unless they are also set to the same channel and group code. Setting the Group Code Set the group code for your radio group from 0-142. Everyone in your group must select the same group code in order to communicate with each other. 3) Press PTT or Power boost to return to normal operation, or press menu/grp to continue to the next section. 2) Press L or M to increase or decrease the number to the desired call tone. Call Tone is cancelled if you press PTT or Power boost. *Range may vary depending on environmental and/or topographical conditions. GMR2889-2CK RADIO CHARGING THE RADIO If you use the rechargeable NiMH battery pack, two radios can be charged directly or by using the supplied charging cradle. GMRS LICENSE The radio operates on the General Mobile Radio Service (GMRS) frequencies when using Channels 1-7 and channels 15-22. You must have a GMRS license issued by the Federal Communications Commission to legally use these channels. For licensing information and application forms, visit the FCC online at: www. fcc. gov/wtb/uls or call the FCC hotline at 1800-418-3676. If you have any questions, you can contact the FCC direct at 1-888-225-5322. No license is required for operation on channels 814 or operation on any channel in Canada. Charge by Using the Radio 1) Connect the DC adapter's plug to the radios DC IN 9V jack and plug other end into your vehicle's accessory power outlet. 2) Charge the battery pack for 16 hours until the battery indicator stops flashing. Using the Charging Cradle 1) Connect the adapter's plug to DC IN 9V jack of the charging cradle and plug the other end into an AC outlet. 2) Set the charging cradle on the desk or tabletop, and place the radio in the charging cradle with the keypad facing forward. Charge the battery pack for 16 hours and remove the radio from the charging cradle after charging. Note: · For charging batteries directly without the cradle, use only the #DC-1002 Cigarette Lighter Adapter code, available from WWW. Uniden. com. · Use only the supplied battery and AC adapter or approved DC adapter from Uniden. · Charge time may vary depending on the battery life remaining. USING THE RADIO IN STANDARD MODE Use the radio in standard (not group) mode when you need to be able to communicate with radios that do not have the group feature. Choosing a Privacy Code You can select a Privacy Code from 1-142 for each channel. [. . . ] PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owner's manual you are certain that the Product is defective, pack the Product carefully (preferably in its original packaging). Disconnect the battery from the Product and separately secure the battery in its own separate packaging within the shipping carton. The Product should include all parts and accessories originally packaged with the Product. Include evidence of original purchase and a note describing the defect that has caused you to return it. The Product should be shipped freight prepaid, by traceable means, to warrantor at: DCS Code List Tone Octal No. [. . . ]