User manual UNIDEN GMR1048-2CK REFERENCE GUIDE

[. . . ] GMR1048-2CK · 15 GMRS / 7 FRS Channels · 99 Sub Codes (CTCSS Tone and DCS Code) · Up to 10 Mile Range* · Scramble · Internal VOX Circuitry · 5 Selectable Call Tone Alerts · Backlit LCD Display · Optional Headset Accessories · Headset Jack · Roger Beep · · · · · · Battery Charger Battery Level Meter Channel Monitor Channel Scan Keypad Lock NOAA Emergency / Weather Channels · Emergency Weather Alert · DC IN 9V Jack Congratulations on your purchase of the Uniden GMR1048-2CK (General Mobile Radio Service) radio. This lightweight, palm-sized, radio is a state-of-the-art device, equipped with many valuable features. Use it at sporting events, to stay in contact with family and friends, hiking, skiing, outdoors, or in a neighborhood watch for vital communication. compartment. Be certain to follow the instructions written on the label on the battery pack. [. . . ] If there is no transmission nor an incoming call within 3 seconds, your radio switches to the Power Save mode. LCD Backlight The LCD Backlight automatically turns ON when any key (except the PTT button) is pressed. Roger Beep Roger Beep is a BEEP that is sent to notify the end of transmission (both PTT and VOX transmission). Roger Beep can be heard through the speaker when both Roger beep and Key Beep are set to ON. When Roger beep is set to ON and Key Beep OFF, Roger Beep will not be heard from the speaker but it will be transmitted to your party. When Roger Beep is set to OFF, Roger Beep neither be herad nor transmitted. To turn ON Roger Beep: Press and hold the L key while turning ON the radio. To turn OFF Roger Beep: Press and hold the L key while turning ON the radio. *Range may vary depending on environmental and/or topographical conditions. CHARGING THE RADIO If you use the rechargeable NiMH battery pack, two GMR1048-2CK radios can be charged directly or by using the supplied charging cradle. Charge by Using the Radio 1) Connect the AC adapter to DC IN 9V jack of the radio and to a standard 120V wall outlet. 2) Charge the battery pack for 16 hours until the battery indicator stop flashing. Using the Charging Cradle 1) Connect the AC adapter to DC IN 9V jack and to a standard 120V AC wall outlet. 2) Set the charging cradle on the desk or tabletop, and place the radio in the charging cradle with the keypad facing forward. 3) Charge the battery pack for 16 hours until the battery indicator stops flashing. Then remove the radio from the charging cradle after completing charging. · Use only the supplied battery and AC adapter or approved accessories from Uniden. · Charge time may vary depending on the battery life remaining. · Battery must be installed for operation, even from external power. GMR1048-2CK RADIO GMRS LICENSE The GMR1048-2CK radio operates on the General Mobile Radio Service (GMRS) frequencies when using Channels 1-7 and channels 15-22. You must have a GMRS license issued by the Federal Communications Commission to legally use these channels. For licensing information and application forms, visit the FCC online at: www. fcc. gov/wtb/uls or call the FCC hotline at 1-800-418-3676. If you have any questions, you can contact the FCC direct at 1-888-225-5322. No license is required for operation on channels 8-14 or operation on any channel in Canada. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Antenna PTT (Push-To-Talk) Button Monitor Button Weather/Alert Key Menu Key Channel Tone/Scan Key Speaker Up/Down Button Headset Jack On/Off Key Call Key Microphone DC IN 9V Battery Level Meter Receive Indicator 16 17 18 19 20 21 22 23 24 25 26 27 28 29 Call Indicator Scan Indicator Channel Indicator Hi Power Indicator Low Power Indicator Alert Indicator Transmit Indicator Volume Setting Indicator Keypad Lock Indicator VOX Indicator Weather Indicator Sub Code Indicator Scramble Indicator Charging Contacts INSTALL THE BATTERY Your GMR1048-2CK radio uses a supplied NiMH battery pack or 4 AAA alkaline batteries (not included). [. . . ] The warranty is invalid if the Product is: (A) damaged or not maintained as reasonable or necessary, (B) modified, altered, or used as part of any conversion kits, sub-assemblies, or any configurations not sold by Uniden, (C) improperly installed, (D) serviced or repaired by someone other than an authorized Uniden service center for a defect or malfunction covered by this warranty, (E) used in any conjunction with equipment or parts or as part of any system not manufactured by Uniden, or (F) installed or programmed by anyone other than as detailed by the owner's manual for this product. STATEMENT OF REMEDY: In the event that the product does not conform to this warranty at any time while this warranty is in effect, warrantor will either, at its option, repair or replace the defective unit and return it to you without charge for parts, service, or any other cost (except shipping and handling) incurred by warrantor or its representatives in connection with the performance of this warranty. Warrantor, at its option, may replace the unit with a new or refurbished unit. THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION OF LAW, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OVERPAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. [. . . ]