User manual UNIDEN DECT1340

[. . . ] The Talk/baTT low light on the handset should light up; if it doesn't, reseat the handset or try plugging the AC adapter into a different outlet. Test the connection 1. You should hear a dial tone, and the Talk/baTT low light should light up. x If you don't hear a dial tone, try checking the connection between the base and the phone jack. (Press End to hang up. ) x If you keep hearing a dial tone, try changing to pulse dialing mode. [. . . ] liquid can be heard in the phone or liquid has entered the handset battery compartment or vent openings on the base), follow these steps: Handset 1. Let dry for at least 3 days with the battery disconnected and the cover off for ventilation. This will cause permanent damage to the handset, base, and the microwave oven. AC Adapter and Battery Information x Use only the supplied AC adapter. The cords on this product and/or accessories contain lead, a chemical known to the state of California to cause birth defects or other reproductive harm. x x x x x Compliance Information FCC Part 68 Information This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US: AAAEQ##TXXXX. An applicable Universal Service Order Codes (USOC) certification for the jacks used in this equipment is provided (i. e. , RJ11C) in the packaging with each piece of approved terminal equipment. A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is also compliant. The REN is used to determine the number of devices that may be connected to a phone line. Excessive RENs on a phone line may result in devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs should not exceed five (5. 0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the telephone provider. The REN for this product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e. g. , 03 is a REN of 0. 3). If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice isn't practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service. battery replacement section); otherwise do not substitute or repair any parts of the device except as specified in this manual. [. . . ] This warranty is void outside the United States of America and Canada. PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owner's manual you are certain that the Product is defective, pack the Product carefully (preferably in its original packaging). Disconnect the battery from the Product and separately secure the battery in its own separate packaging within the shipping carton. The Product should include all parts and accessories originally packaged with the Product. [. . . ]