User manual UNIDEN DCX700

[. . . ] Plug the battery pack connector (red & black wires) into the jack inside the battery compartment. (The connector notches fit into the grooves of the jack only one-way. ) Match the wire colors to the polarity label in the battery compartment, and push the connector in until you hear a click. Make sure you have a good connection by slightly pulling on the battery wires. Place the battery case cover back on the handset by sliding it upwards until it clicks into place. [. . . ] 2)While holding find handset (or intercom for DCT6485 models), connect the AC adapter. 3)On the handset, press and hold # until you hear beep. 3 While the handset is registering, Ha nd s et Re g is t er in g will appear in the handset LCD. When Re g is t ra ti o n C om p le te is displayed, the handset has been registered to the base. If R eg is t ra t io n F a il ed appears, please try these steps again. ­4­ UU869BH_TCX700 OM. fm Page 5 Wednesday, June 2, 2004 10:46 AM Using Your Expansion Handset Now that your new handset is registered, it can perform all the same functions as the handsets originally included with your phone. With your new handset, you can · Transfer calls or intercom between handsets and base (depending on model) · Use two handsets as 2-way radios in DirectLink mode · Use two handsets as a baby/room monitor · Hold 3 or 4-way conference calls (depending on model) · Access your main base's integrated answering device (if available) · Access voice mail using handsets or main base (depending on model) See the owner's manual that came with your main base for complete instructions on operating your new expanded digital phone. Battery Information Low battery alert When the batteries are very low and need to be charged, the phone is programmed to eliminate functions in order to save power. The batteries need to be charged when: - The empty battery icon appears. If you are on a call, complete your conversation as quickly as possible, and return the handset to the charging cradle. Cleaning the battery charging contacts To maintain a good charge, it is important to clean the charging contacts on the handset once a month. Then make sure to go back over the charging contacts with a dry cloth before returning the handset to the charger to charge. Caution: Do not use paint thinner, benzene, alcohol, or other chemical products. Doing so may discolor the surface of the telephone and damage the finish. ­5­ UU869BH_TCX700 OM. fm Page 6 Wednesday, June 2, 2004 10:46 AM I. C. Notice TERMINAL EQUIPMENT NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications. The abbreviation, IC, before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is marked on the equipment itself. The REN assigned to each terminal equipment provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed five. RADIO EQUIPMENT The term "IC:" before the radio certification number only signifies that Industry Canada technical specifications were met. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. "Privacy of communications may not be ensured when using this telephone. " As an Energy Star Partner, Uniden has determined that this product or product models meets the Energy Star guidelines for energy efficiency. THE FCC WANTS YOU TO KNOW Changes or modifications to this product not expressly approved by Uniden, or operation of this product in any way other than as detailed by the owner's manual, could void your authority to operate this product. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. To insure the safety of users, the FCC has established criteria for the amount of radio frequency energy various products may produce depending on their intended usage. [. . . ] THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty is void outside the United States of America and Canada. [. . . ]