User manual UNIDEN BC340CRS

[. . . ] BC340CRS OWNER'S MANUAL OWNER'S MANUAL Precautions Before you use this scanner, please read and observe the following. This scanning radio has been manufactured so that it will not tune to the radio frequencies assigned by the FCC for cellular telephone usage. The Electronic Communications Privacy Act of 1986, as amended, makes it a federal crime to intentionally intercept cellular or cordless telephone transmissions or to market this radio when altered to receive them. The installation, possession, or use of this scanning radio in a motor vehicle may be prohibited, regulated, or require a permit in certain states, cities, and/or local jurisdictions. [. . . ] Rechargeable batteries can be used, but battery life is shorter than with alkaline batteries. · Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable) or rechargeable batteries of different capacities. Setting Up The Scanner 16 Note that the batteries are intended to provide backup power for the clock and for scanning for a short time. When you either install batteries or connect the AC Adapter to a standard US wall outlet, the scanner powers on and goes to STANDBY mode. The scanner remains in STANDBY mode. Connecting an Antenna The scanner uses an external loop antenna to receive AM broadcast stations and an external telescopic antenna to receive all other signals. Connect the supplied rod antenna by pushing the antenna's connector onto the antenna jack on the back of the scanner and twisting it to the desired angle. Connect the two wires from the loop antenna to the AM RADIO ANT terminals on the back of the scanner. * Carefully remove the tube inserted before using the AM Antenna Jack. You can also use an external antenna (not supplied) to help to bring in weaker signals. Use RG58, 50-Ohm lead with a BNC connector to connect the antenna to the scanner. Connect and mount the antenna according to the instructions provided with the antenna. CAUTION: Be sure to follow all safety warnings provided with the antenna. Failure to do so could expose you to risk of injury or death and could severely damage the scanner. Using the Backlight To turn on the backlight for 15 seconds, tap SNOOZE/Backlight. To turn on the backlight permanently, press and hold SNOOZE/Backlight for over 2 seconds. To turn off the backlight, press and hold SNOOZE/Backlight again. Setting Up The Scanner 17 Using the Alarm Clock Your scanner's Clock displays whenever you turn off the radio functions. It can also be used as a standard alarm clock. Setting the Current Time Follow the steps to set the current time: 1. Press L or M to change the hour by one hour increments or press the number keys to select the present hour. Press L or M to change the minute setting by one minute or press the appropriate number keys to enter the minutes. The scanner exits the clock setting mode. Setting the Alarm Clock Follow these steps to set the alarm time: 1. Press L or M to change the hour by one hour increments or press the number keys to select the present hour. Press L or M to change the minute setting by one minute or press the appropriate number keys to enter the minutes. To lock in the alarm time, move the slide switch to Clock. Using the Alarm Clock 18 To have the BC340CRS alert you at the selected time, slide Off/Radio/Tone to either Radio or Tone. If you set the selector to Radio, the alarm will sound with the selected audio source (AM/FM, Scanner, or Weather). [. . . ] · If the scanner receives strong interference or electrical noise, move it or its antenna away from the source of the noise. · Also try changing the height or angle of the antenna. Cleaning · Disconnect the power to the unit before cleaning. · To prevent scratches, do not use abrasive cleaners or solvents. · Do not use excessive amounts of water. Repairs Do not attempt any repair. [. . . ]