User manual UNIDEN 1360

[. . . ] Model 1360 Call Waiting / Caller ID Speakerphone with 12 Number Memory User's Guide Interference Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] 425-555-5555) 11-digits: long distance code 1 + 3-digit area code + 7-digit telephone number (i. e. To dial the displayed number, and the phone is on-hook, pick up the handset or press the speaker button before the timer reaches 0. NOTE: You may select memory locations by pressing review or buttons to scroll through the memory locations or press the 0 - 9, A, B, C. NOTE: If necessary, to erase existing memories, or if you make a mistake, use the delete button. Use the number keys to enter the telephone number (up to 32 digits) and press the store button to save. (The unit will not dial a phone number in this mode. ) The cursor automatically moves to the text line for name entry. Use the number keys to enter the name of the person associated with the telephone number you just entered. For example, to enter the name BILL SMITH, press the 2 key twice for the letter B. NOTE: The ashing cursor automatically moves to the next position or you may press the review or buttons to move the cursor to the next position. Press the arrow key (4) two times to insert a space, and press the 7 key 4 times for the letter S. To enter another name and number in a di erent memory location, return to step 1 and repeat the process. Troubleshooting Tips No Dial Tone · Check all cabling to make sure that all connections are secure and not damaged. · Check hook switch: Does it fully extend when handset is lifted from cradle?No Information is Shown After the Phone Rings · Are you subscribed to Caller ID service from your local telephone company?Phone Dials in Pulse with Tone Service · Make sure TONE PULSE is set to TONE DIAL. Phone Won't Dial Out with Pulse Service · Make sure TONE PULSE is set to PULSE DIAL. Phone Does Not Ring · Make sure ringer switch is set to 1 or 2. Incoming Voice Volume Low · Are other phones off hook at same time?If so, this is normal condition as volume drops when additional phones are used at once. Memory Dialing · Make sure you entered the numbers correctly into memory. Changing a Stored Number Erasing a Stored Number Repeat the storage sequence under "Storing A Name and Number in Memory", and use the delete button to delete the old number before entering the new number. Press the delete button. Copying Caller ID Memories to User Memory If You Did Not Program Your Local Area Code Short Glossary of Terminology Used in this Manual Installing the Phone Your phone should be placed on a level surface, such as a desk or table top, or you can mount it on a wall. Hook switch. The part of the phone that pops up to activate the phone line when the handset is lifted from the base. A term used to describe the phone in its active mode when the handset is o of the base cradle or when the speaker button is pressed. [. . . ] NOTE: The number of new calls is displayed until all new calls have been reviewed. Receiving and Storing CID Calls This units receives and displays information transmitted by your local company. This information can include the phone number, date, and time ;or the name , phone number, date, and time. When the memory is full, a new call automatically replaces the oldest call in memory. The screen displays NEW for calls received that have not been reviewed. [. . . ]