User manual ULINE ORIGINS BI-95BTP INSTALLATION GUIDE

[. . . ] Please carefully follow the directions that apply to your unit and your intended design. WARNING SHOCK HAZARD -- Electrical Grounding Required. · Keep the unit unplugged throughout installation except during testing. · Never remove the round grounding prong from the plug and never use a two-prong grounding adapter. · Always keep your working area dry. CAUTION · Use care when moving and handling the unit. [. . . ] If this treatment is not included in this installation, go on to 5 Adjust Door. Custom 1/4" Thick Door Panel Insert Door Panel Preparation A custom door panel can be inserted into the doorframe. Custom door panels can be flat or raised, as long as the maximum panel thickness where inserted into the door reveal (channel) is 1/4"-thick. For raised panels, the depth of the reveal is 1/4" on all four sides. Figure 14 Figure 15 IMPORTANT Raised panels will reduce the door's 90° swing/zero clearance if the unit is installed next to a wall or similar type of structure (see Page 4). Custom 1/4" Dimensions: Width: Height: 12-15/16" 13-15/32" 2. Start in the middle and pull outward, moving toward the edge (see Figure 15). Holding door gasket out of the way, replace handle on door, making sure it is seated properly on insert and that screw holes line up. Starting at the corners and working inward, push door gasket into place on door. Go on to 5 Adjust Door. Figure 16 The door panel must not weigh more than 20 lbs. Door Panel Installation Install the insert as follows: CAUTION Use care when handling the insert. Remove top hinge screw pin with a Phillips head screwdriver (see Figure 14). Remove door by tilting forward and lifting off bottom hinge pin. 02/2005 7 www. U-LineService. com WH95TP, BI95BTP and BCM95 Ice Makers 5 Adjust Door 6 Prepare Plumbing CAUTION Plumbing installation must observe all state and local codes. All water connections MUST BE made by a licensed/ qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm. Checking Door Alignment The unit's door is aligned at the factory before shipment. The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A power supply (normal household current) or a 220 VAC, 50/60 Hz power supply. An individual, properly grounded branch circuit or circuit breaker is recommended. GFCI (ground fault circuit interrupter) is usually not required for fixed location appliances and is not recommended for your unit because a GFCI could be prone to nuisance tripping. See Figure 21 for recommended receptacle location. Water Line Figure 18 Figure 19 2. Slide the compression fitting and ferrule over the 1/4-inch OD water supply line. Using two wrenches, tighten the compression fitting on the supply line (see Figure 18). Carefully bend the water supply line into position and connect the line to the solenoid valve (see Figure 19). [. . . ] Do not overtighten. Installation Troubleshooting Q: Problem Water is leaking under the unit. A: Solution A water leak under the unit is most likely caused by a bad connection in the water supply line. Make sure the water line's brass fitting is screwed tight to its valve and threaded correctly. Make sure that plumbers tape was NOT used; if it was remove all traces before reinstalling. IMPORTANT It is possible that dirt or scale will dislodge in the water line. Always throw away all ice cubes made during the first twenty-four (24) hours of operation. 02/2005 11 www. U-LineService. com Start-Up Troubleshooting Who to Call Q: Problem Unit does not appear to turn on when plugged in. Service Information If the need for service arises, contact the dealer from whom the unit was purchased. [. . . ]