User manual ULINE ECHELON CO2075DWR

[. . . ] INTRODUCTION Congratulations on your purchase of your U-Line drawer unit. A pioneer in the field for more than 40 years, U-Line is the world's number one manufacturer of built-in, under-counter ice making and specialty refrigeration products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology leads the market with innovation, design, depth of product line and performance. [. . . ] It consists of an LED display, two LED status indicator lights and three touch pad buttons. The LED display shows the refrigerator temperature set point and is calibrated in degrees Fahrenheit. The controller is factory programmed for a set point of 38°F for the top drawer which will show when the unit is first powered up. To display actual refrigerator temperature, press the "WARMER" button momentarily. A solid status indicator light (1, Figure 22) will show the air temperature reading in the cabinet for approximately 10 seconds. To adjust the temperature set point, press the "SET TEMP" button momentarily; the display will flash. Press the "WARMER" or "COOLER" button as desired to change the set point. When the desired set point shows on the display, you can press the "SET TEMP" again or wait 10 seconds and the new set point will be saved and the display will stop flashing. Wait 24 hours for the temperature to stabilize before checking the actual temperature again. The refrigerator set point range is 34°F to 45°F. 25 User's Manual NOTE The temperature will be the air temperature in the unit and NOT the temperature of your product. The temperature may be higher or lower than your set point; this is the normal air temperature when maintaining a STABLE product temperature. Wait at least an hour to check the unit again before changing set point. To check the actual temperature in the ice compartment, press the WARMER button momentarily, and then press and hold "COOLER" for 3 seconds. NOTE The ice compartment set temperature is 0°F and cannot be set. The temperature may vary while cycling or when the unit is in the self defrost mode. The temperature may adjust itself slightly up or down to match the refrigerator set point if it changes from 38°F. The temperature will be the air temperature and may vary between +10°F and ­10°F. During defrost or after loading product, the temperature may appear higher temporarily. LED 1 2 Status · Solid · Flashing · Solid · Flashing Indicates · Refrigerator Temperature displayed · Not Applicable · Freezer Temperature displayed · Open Thermistor ­ call for service Table 2. Indicator Light Status - 26 Temperature Controller DWR034 Figure 23 The temperature controls are integrated in the top, front drawer panel. They consist of an LED display and touch sensors for each drawer and a touch sensor to control the lighting (" ", " " and " "). The LED displays show the drawer's temperature set point, and are calibrated in degrees Fahrenheit. The controls are factory programmed for a set point of 60°F for the top drawer and 40° F for the bottom drawer. [. . . ] WARNING DO NOT use solvent cleaning agents or abrasives on the interior. These cleansers may damage or discolor the interior. Condenser Cleaning ­ Every 3 Months !WARNING Disconnect electric power to the unit before cleaning the condenser. 41 User's Manual To remove and replace the grille for access to the condenser fins follow this procedure: DWR019 Figure 36 1. Clean the condenser coil using a soft brush with a "combing" action or vacuum cleaner. [. . . ]