User manual ULINE ECHELON CLRCO2175

[. . . ] Use and Care Guide Clear Ice Maker Model: CLR2160 Clear Combo® Ice Maker/Refrigerator Model: CLRCO2175 CLR2160 CLRCO2175 1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world's number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology consistently leads the market with innovation, design, depth of product line and performance. [. . . ] The display (Figure 9, 3) will switch from ICE to OFF to confirm that the ice maker is off. Remove all ice from the storage bin. Clear Ice Maker Maintenance Self-Cleaning Cycle Interval - Every Six Months To maintain operational efficiency, clean the unit every six months (depending on water conditions, more or less frequent cleaning may be necessary). If the ice maker requires more frequent cleaning, consult a qualified plumber to test the water quality and recommend appropriate treatment. 1 WARNING Wear rubber gloves and safety goggles and/or face shield when handling Ice Machine Cleaner. CAUTION Use only U-Line Ice Machine Cleaner (P/N 41978, available from your dealer or direct from U-Line). It is a violation of federal law to use this solution in a manner inconsistent with its labeling. Use of any other cleaner can ruin the finish of the evaporator and will void the warranty. U-Line Ice Machine Cleaner is used to remove lime scale and other mineral deposits. Refer to the following steps to initiate the self-cleaning cycle. ULIN_0059_A Figure 10 3. Remove inside front cover (Figure 10, 1). IMPORTANT · The Model CLRCO2175 refrigerator will not operate during the ice maker cleaning cycle. · Model CLRCO2175 ice production after the first harvest may take longer after the cleaning cycle since restoring the refrigerator temperature will take precedence over ice production. Once the refrigerator reaches its set-point temperature, ice making will resume. 1 ULIN_0060_A IMPORTANT Never use anything to force ice from the evaporator. Remove the overflow tube (Figure 11, 1) by lifting it up while using a slight back and forth motion to loosen 12 CLR2160, CLRCO2175 it from the drain hole. Replace the overflow tube after all of the water has drained from the reservoir. Touch and release the LIGHT button (Figure 9, 4) three times, then release the ON/OFF button (Figure 9, 1). The display (Figure 9, 3) will show "CL" to confirm the beginning of the cleaning cycle. When water begins to flow over the evaporator (approximately three minutes), add one package of ULine Ice Machine cleaner to the water reservoir. When the self-cleaning process stops (approximately 45 minutes) the unit will remain off for an additional 15 minutes. When clean cycle is completed, display will automatically switch back to set temperature and unit will run as normal operation. Sanitize the bin with a solution of 1 tablespoon of bleach in 1 gallon of warm water. To ensure that the drain system is working properly, pour 1 gallon of cool, fresh water into the ice bin. If your unit is equipped with a drain pump, it should drain the ice bin. When ice production resumes, the water fill valve will energize, fill the water reservoir, and shut-off after three minutes. The compressor begins to operate and water flows over the evaporator assembly (ice cube tray). [. . . ] Pressing light button will turn interior light on for 4 hours, then it will turn off. Hold Display off when door is closed (unless cabinet light is switched on). Repeat to switch back. Cabinet Light Display Off Mode All Ice Makers Task Touch Touch Display Comment Ice Maker Off Mode Hold Repeat to switch back Clear Ice & Clear Combo Only Task Clean Cycle Ice Thickness Adjustment Temporary Shutdown (Office Mode) Touch Hold Touch Display Comment Will automatically return to ice production when clean cycle is complete. Ice maker will automatically turn back on in three hours. Hold Hold NOTE: 38°F is an example; the display will vary with actual set-point. IMPORTANT Factory recommended set-point is 38°F for refrigerators and beverage centers, and 50°F for wine coolers. 22 CLR2160, CLRCO2175 U-Line Corporation Limited Warranty U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase. [. . . ]