User manual ULINE ECHELON 2075WC

[. . . ] É c h e l o nTM ® U S E R M A N U A L U-LINE CORPORATION LIMITED WARRANTY U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase. During the initial one-year warranty period for all U-Line products U-Line shall: (1) at U-Line's option, repair any product or replace any part of a product that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii)and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part. During years two through five of the warranty period for the sealed system, U-Line shall:. (1) repair or replace any part of the sealed system that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii)and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part of the sealed system. [. . . ] WARNING To prevent permanent damage to the inner liner of your Wine Captain®, the wine rack wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours per coat) in accordance with the stain/finish manufacturer's instructions prior to re-installing the wood trim inside the cabinet of the Wine Captain®. Failure to do so may cause the inner liner of the unit to have a permanent odor, which is not covered by the warranty. (1) You can leave as is, (2) add a final finish coat or (3) you may stain the wood trim. The final finish coat was not applied at the factory so that the wood trim could be stained. Review the following guidelines when staining and or sealing the wood to ensure proper adhesion and durability of the finish. Remove five racks with wood trim from unit, see RACK REMOVAL/INSTALLATION. Apply a thin coat of a clear protective finish; the factory-applied seal is compatible with virtually all finishes. A low odor, water clean up, quick drying finish such as Minwax Polycrylic is recommended. 11 6. User's Manual To stain for a different wood color: 1. Remove five racks with wood trim from unit, see RACK REMOVAL/INSTALLATION. Apply Minwax Water-Based Wood Stain to wood with a synthetic foam brush. After this period, while stain is still wet, take a stain dampened rag and remove all excess stain. Wipe in the direction of the grain with medium pressure to achieve the desired stain color. If desired sand the wood with very fine sandpaper to smooth the surface from the staining process. Apply one coat of Minwax Ultra Fast-Drying Polycrylic Protective Finish with a synthetic foam brush to the wood. This finish should be applied in a thin coat following the direction of the grain. Next apply the finish to the front side of the wood and allow to dry for two hours. Allow the final coat to dry for 24 hours before installing the wood to the Wine Captain® racks. 4. 7. 8. 12 LEVELING THE UNIT Position the unit on a flat, level surface, capable of supporting the entire weight of the unit when full. Turn the legs clockwise to raise and counterclockwise to lower (see Figures 3 & 4). CHECK LEVEL TURN FOOT TO ADJUST UL105 UL314 Figure 3 Figure 4 REVERSING THE DOOR All Wine Captain® models (except Stainless Steel models which must be ordered left or right hand opening) are field reversible for left or right hand opening. The door opening is easily reversed by moving the hinge hardware to the opposite side (see Figure 5). UL318 Figure 5 13 User's Manual To reverse the door: 1. [. . . ] Never use abrasive cleaning agents. CAUTION Stainless steel models exposed to chlorine gas and moisture, such as areas with spas or swimming pools, may have some discoloration of the stainless steel. Discoloration from chlorine gas is normal. INTERIOR CLEANING -- AS REQUIRED 1. Wipe down the interior with a solution of non-abrasive mild detergent and warm water. Reconnect power to the unit. 20 CONDENSER CLEANING - EVERY 3 MONTHS ! [. . . ]