User manual TYAN TIGER I7520SD

[. . . ] Tiger i7520SD /// Version 1. 2 S5365 Copyright Copyright © TYAN Computer Corporation, 2006. No part of this manual may be reproduced or translated without prior written consent from TYAN Computer Corp. Trademark All registered and unregistered trademarks and company names contained in this manual are property of their respective owners including, but not limited to the following. Intel, Sossaman, and combinations thereof are trademarks of Intel Corporation. IBM, PC, AT, and PS/2 are trademarks of IBM Corporation. Notice Information contained in this document is furnished by TYAN Computer Corporation and has been reviewed for accuracy and reliability prior to printing. [. . . ] However, if you don't use any USB 2 devices, set the option to Disabled. Enabled / Disabled Legacy USB Support This option is used to enable the support for Legacy Universal Serial Bus. Disabled / Disabled 43 OnChip PCI-E LAN1 Controller This option is used to enable/disable OnChip PCI-E LAN1 controller. Enabled / Disabled Invoke Boot Agent This option is used to enable/disable Lan Boot ROM during BIOS post. Disabled / Disabled 44 3. 3. 2 Advanced Processor Options This section allows you to fine-tune the processor options. Processor Power Management This option is used to select the Processor Power Management desired. Processor Enable This option is used to enable the CPU for use by the operating system. Enabled / Disabled 45 3. 3. 3 I/O Device Configuration This setting allows you to configure I/O devices. Floppy Disk Controller This defines how the floppy disk controller is detected and configured. Enabled/ Disabled Serial Port A: This defines how the first serial port is detected and configured. Enabled / Disabled Base I/O address: This feature is used to set the base I/O address for serial port A. 2F8 / 3F8 / 3E8 / 2E8 Interrupt This feature is used to set the interrupt for serial port A. IRQ3 / IRQ4 Serial Port B: This defines how the first serial port is detected and configured. Enabled / Disabled 46 Mode This feature is used to set the mode for serial port B. Normal / IrDA / ASK-IR Base I/O address: This feature is used to set the base I/O address for serial port B. 2F8 / 3F8 / 3E8 / 2E8 Interrupt This feature is used to set the interrupt for serial port A. IRQ3 / IRQ4 Parallel port: This defines how the parallel port is detected and configured. Enabled / Disabled Base I/O address: This feature is used to set the base I/O address for parallel port. 378 / 278 / 3BC Interrupt This feature is used to set the interrupt for parallel port. IRQ7 / IRQ5 Mode This feature is used to set the mode for parallel port. ECP / Output Only / Bi-directional / EPP DMA Channel This feature determines which DMA channel the parallel port should be used when it is in ECP mode. DMA3 / DMA1 Restore on AC Power Loss This option is used to set the state of restoring system on AC power loss. Power off: Stay in power off mode Power on: Stay in power on mode Last State: Stay in last system state 47 3. 3. 4 Console Redirection Com Port Address If enabled it will use a port on the motherboard. Disabled / On-board COM A / On-board COM B Baud Rate This feature is used to enable the specified baud rate. [. . . ] Striping: see RAID 76 UltraDMA-33/66/100: a fast version of the old DMA channel. Without proper UltraDMA controller, your system cannot take advantage of higher data transfer rates of the new UltraDMA/UltraATA hard drives. This one port type can function as a serial, parallel, mouse, keyboard or joystick port. It is fast enough to support video transfer, and is capable of supporting up to 127 daisy-chained peripheral devices. [. . . ]