User manual TRUSTMASTER CHALLENGE 2

[. . . ] Contents, designs and specifications are subject to change without notice and may vary from one country to another. [. . . ] to obtain an effect similar to the one produced by the analog C-stick on the GamecubeTM gamepad , press and hold down one of the arrows. For example, if you press and hold down the upwards arrow, the camera will move progressively upwards. The function of every digital button (A, B, X, Y, Z, Trigger click L, Trigger click R) can be applied to another digital button or lever. The function of each lever can be applied to a digital button or lever. The Start/Pause, Program, Rumble on/off and Shift D-Pad/C-stick buttons, the 4-way D-Pad arrows and the left and right wheel directions cannot be programmed. Press the button/axis that you wish to program elsewhere: the LED turns yellow**. Press the button/axis that you wish to program with the same function as the button/axis pressed in Step 2, above: the LED turns green, and then turns off. Therefore, "press an axis" or "select an axis" means activate a lever. [. . . ] Example: If you have applied the A button's function to the right-hand lever (as in the example above) and you would like to reset the function of the right-hand lever, hold down the Program button for at least 5 seconds. [. . . ]