User manual TROY-BILT 13104

[. . . ] Owner/Operator Manual LTX Lawn Tractors · · · · Safety Controls Operation Maintenance Models 13102 --13 HP Gear Drive 13103 --13. 5 HP Hydro Drive 13104 --15. 5 HP Hydro Drive 13105 --16 HP Twin/Hydro Drive ©1997 GARDEN WAY INCORPORATED Form 1774269 (9/97) Introduction Thank you for purchasing this product. All information in this manual is based on the latest product information available at the time of printing. This manual is considered a permanent part of the unit and must stay with the unit if resold. This is a safety, operation and general maintenance manual which does not attempt to cover major repairs. [. . . ] 4-2 & 4-4)--Gear Shift Lever [model 13102] Controls forward and rearward movement of tractor. 4-2)--Travel Pedal [models 13103, 13104, 13105] Controls forward and rearward movement of tractor. Pressing top of pedal moves unit forward, pressing bottom moves unit in reverse. Transmission is in neutral when pedal is centered. Features & Controls (continued) U S Fuel Fill Cap Fuel Tank ON OFF Fig. 4-7 Electric Lift (Optional­standard on Model 13105 only) correctly set. If parking brake will not engage, service brake immediately--DO NOT OPERATE UNIT!4-3)--Attachment Lift Lever [not on model 13105/ electric lift equipped units] Controls attachment lift. The lift lever has seven settings that allow you to regulate the height of the attachment in approximately 1/2" increments. 4-7)--Electric Lift Switch [Optional--standard on model 13105] Allows finger-tip operation of attachment lift. 4-6)--Attachment Height Indicator Decal and pointer provide a visual reference to the height setting of the mower deck, from No. 4-3), the numbers on the decal coincide with the seven positions on the attachment lift handle. Re-adjust at attachment hitch arm mounting bracket (see "Mower Height Indicator Adjustment" in Section 6). On models with an electric lift, the mower height adjusting knob (O, FIg. 4-2) will control the mower height setting and the pointer will indicate that final setting. After adjusting the mower deck to the desired cutting height, note the location of the pointer so that you can return to this position when desired. Note: When mowing using the ground contour following method, the pointer will move back and forth as the deck follows the contour of the ground. Headlights (models 13103, 13104, 13105 only) Headlights turn on when engine starts and turn off when engine is stopped. On model 13105, headlights will turn on when ignition key is in run (middle) position and engine is not running. Note: Battery will discharge (and hour meter and headlights on Model 13105 will operate) if ignition switch is on when engine is not running. 14 Section 5 Operation PRE-OPERATION CHECKLIST A Perform the following checks each time before using the unit: OIL FILL FU LL WARNING BEFORE OPERATING THE UNIT, READ AND UNDERSTAND ALL SAFETY, CONTROLS AND OPERATING INSTRUCTIONS IN THIS MANUAL. ALSO, READ ALL MATERIAL PROVIDED WITH ANY ATTACHMENTS TO BE USED WITH THE UNIT. READ AND FOLLOW ALL SAFETY AND OPERATING INSTRUCTIONS ON THE DECALS ON THE UNIT AND ATTACHMENTS. A AD D A LL FU AD D AUTION-- DO N OT O C VERFILL CAUTION Fig. Level should be between "Full" and "Add" marks (Fig. If necessary, add oil to crankcase through dipstick opening. B Fuel Tank CAUTION DO NOT ADD OIL BEYOND FULL MARK. [. . . ] · Adjust belt guides (D) 1/16" to 1/8" away from belt. · Adjust belt guide (E) so it is pointing 50° back from straight left, as shown in Fig. HYDROSTATIC DRIVE UNITS: · Route belt around sheaves as shown in Fig. · Adjust belt guides (E) 1/16" to 1/8" away from belt. [. . . ]