User manual TRONIC KH 378 PORTABLE TOP-LOADING CD-PLAYER WITH RADIO

[. . . ] We wish to point out that even standard vehicle models are equipped with numerous electronic devices (ABS, ASR, on-board computer, etc. The high starting voltage and voltage peaks may cause damage to these electronic components. We cannot assume any liability for consequential damage caused by the jump starts function. [. . . ] The power station has to be charged to full capacity in order to draw a current of 600 A for 5 seconds. Connect the red cable (+) of the power station with the POSITIVE pole (+) of the vehicle battery. Connect the black cable (-) of the power station with the body of the vehicle, for example to the grounding strip or any other bare point on the engine block. Clamp this cable as far as possible from the battery in order to prevent ignition of any explosive gas that may develop. The switch (Figure 1 / Item 1) must be in the "ON" position when performing a jump start. After two minutes you may attempt to start the engine with the power station connected. Be sure not to attempt to start the vehicle for longer than 5 seconds due to the very high current involved. After the successful start, first disconnect the pole clamp on the grounding strip (negative pole). Then disconnect the jumper cable from the POSITIVE pole (+) of the car battery. ⷠProtect the power station from rain, splashes, and dampness in order to avoid mortal danger of electric shock. ⷠNever place the device on or near a heat source in order to avoid damage. ⷠNever charge more than one battery at a time, and never try to charge non-rechargeable batteries, as these could explode. Check that all the voltage and current ratings of the consumer units will not overload the power station. Yellow The battery is 0 - 50 % full and should be recharged · red The battery is completely run down. Continuing to operate the unit in this condition may damage the battery. The storage battery discharges automatically when the power station is not used for a long time. It should be recharged every 3-5 months, regardless of the amount usage, in order to preserve the operating life of the battery. Important Information for your Safety" prior to working with the compressor. [. . . ] Allow the compressor to cool for at least 10 minutes after it has run for 10 minutes. ⷠCheck the pressure gauge before switching on the compressor (Fig. 1 / Item 6) together slightly from the sides, then pull the cover off. [. . . ]