User manual TRONIC KH 205 WIRELESS DOORBELL

[. . . ] The appliance is intended for domestic use only, not for commercial or industrial applications. No warranty is provided for damages resulting from improper use of the appliance!5 V Batteries, Type "AA/Mignon/LR6" 12 V Battery, Type 23A Stand for the receiver Screws for fixing the sender on to the assembly plate Nameplates Wallplugs with screws for sender assembly Wallplug with a screw for receiver suspension Operating manual Do not permit children to handle electrical appliances without supervision, as they cannot correctly assess the possible dangers of injury. This appliance is not intended for use by individuals (including children) with restricted physical, physiological or intellectual abilities or deficiences in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the appliance is to be used. [. . . ] Selecting the call melody There are 16 different call melodies stored in the appliance. The appliance will utilise the last melody it played as the call melody. Synchronising the sender and receiver The sender and receiver in this doorbell system can communicate with each other over a number of different frequencies. Therefore, several doorbell systems can be operated within the appliance range without them disturbing each other. The precondition for this is that the sender and receiver within a system are working on the same frequency. For this, you must synchronise the appliances as follows: Press the synchronisation button on the receiver The red signal indicator now glows. If the synchronisation has been a success, the receiver notifies you of the programmed call signal. Should the receiver not react as described, repeat the synchronisation. The sender shows, with a brief glowing of the indicator f when being activated, the transmission of the signal to the receiver. Installing the appliance Select a suitable positioning for the sender, close to your outer door. Using the assembly plate j of the sender, mark the positions required for the two boreholes (spacing approx. Carefully slide the plastic covering over the nameplate d to the side and then remove it. Write the name(s) of the residents on the plate d and then replace the plastic covering. Place the sender on the assembly plate j and secure it, with the enclosed small screws, to the assembly plate j. You can install the receiver at a suitable location either suspended by its loop o or make use of the stand t. If being utilised in a building, this range is reduced quite distinctly. To suspend the receiver, fix the enclosed screw, with the wallplug, at a suitable location on the wall and hang the appliance from it. In the event of malfunction or apparent damage, make contact with Customer Services. If the appliance is not to be in use for an extended period, remove the batteries. NEVER submerse the appliance or its components in water or other fluids! [. . . ] You receive a 3-year warranty for this device as of the purchase date. The appliance has been manufactured with care and meticulously examined before delivery. In the case of a warranty claim, please make contact by telephone with our service department. The warranty covers only claims for material and maufacturing defects, not for worn parts or for damage to fragile components, e. [. . . ]