User manual TRICITY MW219TC

[. . . ] - - - - - - - - - - - - - - - - - - - - 25 Technical data- - - - - - - - - - - - - - - - - - - - - 29 Consumption values - - - - - - - - - - - - - - - - 30 Installation instructions - - - - - - - - - - - - - - 31 Environmental concerns - - - - - - - - - - - - - 35 2 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, cleaning and maintenance. Under no circumstances should you attempt to repair the machine yourself. [. . . ] Close the door. 16 Pull out the dispenser drawer until it stops. Measure out the amount of detergent required, pour it into the main wash compartment and, if you wish to carry out a programme with the prewash phase, pour it into the compartment marked . If required, pour fabric softener into the compartment marked (the amount used must not exceed the «MAX» mark in the drawer). Select the required programme by turning the programme selector dial (1) Turn the programme selector dial to the required programme. On position «O» the programme is reset and the machine is switched OFF. At the end of the programme the selector dial must be turned to position «O», to switch the machine off. If you turn the programme selector dial to another programme when the machine is working, the red light of the button 8 flashes 3 times and the message Err is displayed on the display to indicate a wrong selection. Select the spin speed or the Rinse Hold option by pressing button 2 When selecting a programme, the light corresponding to the maximum speed allowed for that programme will illuminate (refer to the section «Programme table» for the maximum allowed spin speed). Select the degree of dryness or the duration of the drying cycle by pressing buttons 3 and 4 By pressing button 3 it is possible to select an automatic degree of dryness for cotton or synthetics items. The washer dryer will automatically adjust the duration of the drying cycle to the selected degree. Also, the button 4 allows you to select a drying time for Cottons and Synthetics from 10 minutes to 130 minutes (2. 10). Opening the door after the programme has started First set the machine to pause by pressing button 8 . If this light doesn't go off and the door remains locked, this means that the machine is already heating, that the water level is above the bottom edge of the door. If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to «O». After a few minutes it will be possible to open the door (Pay attention to the water level and temperature!). After this procedure, it will be necessary to set the programme and the options again and then to press button 8 . Some acoustic signals sound and on the display will appear a flashing «0». The door can be opened. 18 If, at the end of a programme, there is water in the tub, (the light 9 still on) to empty out the water follow the following instructions: To empty out the water proceed as follows: 1. at the end of the programme, the display shows «0», the light 9 goes off. It will be possible now to open the door. Turn the programme selector dial to «O» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. Leave the door open to prevent the formation of mildew and unpleasant smells. Operating sequence - Drying only The max load to dry in your washer -dryer is 3 kg for cotton and 2 kg for synthetics. [. . . ] Before connecting the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. In the interest of the environment Washer-dryers should be connected to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being discharged safely into a river. It is essential that these appliances are not connected to the surface water drainage system as this water is discharged directly into a river or stream and may cause pollution. If you require any further advice please 33 The drain hose may be extended to a maximum of 4 metres. [. . . ]