User manual TRENDNET TPL-401E QUICK INSTALLATION GUIDE

[. . . ] Existing 10/100Mbps wired network when TPL-401E is used as a bridge device ?Additional 200Mbps HomePlug ® AV or IEEE 1901 compliant powerline adapter (e. g. TRENDnet TPL-303E, TPL-304E, TPL-305E, TPL-310AP, or another TPL-401E) (Note: This requirement is for the TPL-401E only. [. . . ] This TPL-401E should be located within the reach of the router's network cable. Outlet 2. Connect a network cable from the TPL-401E to an available LAN network port on your router (e. g. Plug a second TPL-401E into an available power outlet where your remote computer or network appliances (e. g. Game Console, IP Set box, network enabled TV, etc. ) are located. Outlet 3 4. Connect a network cable from the TPL-401E network port into the network port on your remote computer or network appliance (e. g. Game Console, Blu-ray player, IP Set box, network enabled TV, etc. ). Outlet 5. Verify that the PWR (Power), PL (Powerline) and ETH (Ethernet Link/ACT) LEDs are on for both TPL-401E adapters. Your installation is now complete For detailed information regarding the the TPL-401E/TPL-401E2K, configuration and advanced settings, please refer to the Troubleshooting section, User's Guide on the Utility CD-ROM, or TRENDnet's website at http://www. trendnet. com. Register Your Product To ensure the highest level of customer service and support, please take a moment to register your product Online at: www. trendnet. com/register Thank you for choosing TRENDnet 4 3. LEDs and Buttons PWR (Power) ETH (Ethernet Link/ACT) PL (Powerline) The Gigabit Ethernet/Network Port and Reset buttton are located at the bottom of the device. Gigabit + Ethernet / Network Port Reset Button Sync Note: Please refer to the User's Guide on the TPL-401E/TPL-401E2K's User's Guide CD for detailed explanations of each LED and button. 5 Troubleshooting 1. I have verified that my Powerline device is connected to my workstation, but I cannot detect other Powerline devices. 2. Verify that the power outlet of the TPL-401E adapter is plugged into is on the same electrical system and/or circuit breaker box. 3. If you are still not able to establish connectivity after performing the above steps, please reset both of the TPL-401E adapters to factory default. With a pin or paperclip, press and hold the reset button for 1 second and release it. To verify connectivity, the PL LED will become solid when the powerline adapters establish connectivity. The TPL-401E powerline adapters must have the same network name/key in order to connect to each other. Note: If you have problems resetting the device, unplug the powerline adapter(s) from the power outlet, wait 15 seconds and plug the adapter(s) back into the outlet, then repeat the reset procedure. I can detect my Powerline devices on my Powerline network, but I cannot connect to the Internet. Make sure you are not connecting the device into a surge protector or power strip. Make sure that your Router is connected to the Internet and one of the Router's LAN ports is connected to the TPL-401E's network port). [. . . ] No, the TPL-401E adapter should automatically establish connection once both units are reset to default settings. If you still encounter problems or have any questions regarding the TPL-401E, please refer to the User's Guide included on the Utility CD-ROM or contact TRENDnet's Technical Support Department. 7 Description of Modes Erp (EuP) Operation: Standby Mode The EUT has no external mechanical switch and uses an internal program to control active and standby modes. Disconnect the Ethernet cables from the device Ethernet ports, and after 3 minutes, the device will enter standby mode. [. . . ]