User manual TRENDNET TL2-E284

[. . . ] Table of Contents CHAPTER 1 PREFACE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 ABOUT THIS GUIDE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 TERMS/USAGE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 CHAPTER 2 PRODUCT INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Specify the time period that a client waits for the response from the RADIUS server before re-sending the request. The maximum number that a client re-sends the request when there is no response from RADIUS server. The possible number is 1-254 times. Response Time (secs) Retry Count Click Apply to submit the changes the setting of an existing RADIUS server, Delete to delete one. 6-21 24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots IGMP Snooping IGMP Snooping Configuration This page is to configure the IGMP Snooping global settings. Figure 59 ­ Layer2 Management > IGMP Snooping > Basic Settings Parameter System Control Description To activate or shutdown IGMP snooping of the Switch. Default is Start. Click Start to start or shutdown the IGMP Snooping globally. Parameter Select IGMP Snooping Status Operational Status Snooping Mode Report Forwarding Description Select a line to change the configuration. Select All Ports to forward the report to all ports, Router Ports to forward the reports to IGMP router ports only. To set the maximum retries for group specific queries which sent to a port received an IGMPv2 leave message. Specify if the IGMP queries will still be sent when STP topology change happens. Default is Disabled. Retry Count (1~5) Query Transmit On TC Click Apply to submit the changes. IGMP Snooping Timer Configuration This page is to configure the IGMP Snooping timers. 6-22 24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots Figure 60 ­ Layer2 Management > IGMP Snooping > Timer Configuration Parameter Router Port Purge Interval (60~600 Secs) Group-Member Port Purge Interval (130~2335 Secs) Report Forward Interval (1~25 Secs) Group Query Interval (1~5 Secs) Querier Query Interval (60~600 Secs) Description To set the time-out period that an IGMP multicast router port hasnt received IGMP router control packet, it will be deleted. To set the purge interval that an IGMP member port hasnt received IGMP report packet, it will be deleted. To set the time interval that IGMPv2 report of the same group will not be forwarded to the router ports. Default is 125 seconds. Click Apply to submit the changes, Reset to clear the values. IGMP Snooping Interface Configuration This page is used to configure the VLAN basis IGMP snooping settings. Figure 61 ­ Layer2 Management > IGMP Snooping > Interface Configuration Parameter VLAN ID IGMP Snooping Status Fast Leave Querier Status Router Port List Description Specify which VLAN to add to the IGMP snooping interface list below. Specify the IGMP router ports of this VLAN. Click Add to add a new VLAN to the list, Reset to clear the value. Parameter Select VLAN ID IGMP Snooping Status Current Version Fast Leave Querier Status Router Port List Description Select which VLAN to apply the configuration changes. Specify the IGMP router ports of this VLAN. Click Apply to submit the changes the IGMP snooping setting of an existing VLAN, Delete to delete one VLAN from the list. 6-23 24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots IGMP Snooping VLAN Router Ports This page is to display the static and dynamic learned IGMP router ports of each VLAN. Figure 62 ­ Layer2 Management > IGMP Snooping > Router Ports MAC Based Multicast Forwarding Table This page is to display the IGMP group MAC address was learned. Figure 63 ­ Layer2 Management > IGMP Snooping > Group Information Static MAC Entries Static MAC Address Configuration This page is to create or configure static unicast MAC address in the L2 forwarding database. Figure 64 ­ Layer2 Management > Static MAC Entries > Unicast Entries Parameter VLAN ID MAC Address Allowed Port Status Description Specify the VLAN ID of the new MAC address entry. DeleteOnReset - The static multicast will be deleted after switch reset. DeleteOnTimeout - The static multicast will be deleted when aging time out. Default is Permanent. Click Add to create a new static MAC, Reset to clear the value. 6-24 24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots Parameter Select VLAN ID MAC Address Allowed Port Status Description Select which MAC address to apply the configuration changes. [. . . ] TL2-E284 ­ 3 Years Warranty AC/DC Power Adapter, Cooling Fan, and Power Supply carry 1 year warranty. If a product does not operate as warranted during the applicable warranty period, TRENDnet shall reserve the right, at its expense, to repair or replace the defective product or part and deliver an equivalent product or part to the customer. The repair/replacement unit's warranty continues from the original date of purchase. TRENDnet shall not be responsible for any software, firmware, information, or memory data of customer contained in, stored on, or integrated with any products returned to TRENDnet pursuant to any warranty. [. . . ]